User manual

Cleaning and Maintenance
52
3. Use an anti-scratch sponge with brass
filaments on tougher encrustations.
4. In case of grease residues use specific
oven cleaning products.
5. Remove the residual water inside the
oven.
For greater hygiene and to avoid food
being affected by any unpleasant odours,
we recommend that the oven is dried using
a fan-assisted function at 320°F for
approximately 10 minutes.
What to do if...
The display is completely off:
• Check the mains power supply.
• Check whether an all-pole
disconnection switch upstream of the
appliance supply line is in the “ON”
position.
The appliance does not heat up:
• Check whether the "showroom" mode
has been set (for further details see 2.8
Secondary menu).
The controls do not respond:
• Check whether the "child lock" mode has
been set (for further details see
“Secondary menu”).
The cooking times are longer than those
indicated in the table:
Check whether it has been set in “eco-
logic” mode (for further details see
“Secondary menu”).
If the door is opened during a fan assisted
function, the fan stops:
• This is not a fault. It is a normal operation
of the appliance, useful when cooking
foods in order to avoid excessive heat
escaping. When the door is closed, the
oven will return to normal operation.
We recommend wearing rubber
gloves for these operations.
For easier manual cleaning of
parts that are difficult to reach, we
recommend removing the door.
If the problem has not been
resolved or in the case of other
types of fault, contact your local
technical support centre.
If other ERRx error messages are
indicated:
Note down the error message,
function and set temperature and
contact your local technical
support centre.