User Manual Benutzerin‐ formation Hob SI1F7645B Kochfeld
CONTENTS Safety information Safety instructions Product description Daily use Flexible induction cooking area Hints and tips 2 4 6 8 12 16 Care and cleaning Troubleshooting Installation Technical data Energy efficiency 18 18 21 23 24 Subject to change without notice. SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damages that are the result of incorrect installation or usage.
General Safety • • • • • • • • • • • • WARNING: The appliance and its accessible parts become hot during use. Care should be taken to avoid touching heating elements. Do not operate the appliance by means of an external timer or separate remote-control system. WARNING: Unattended cooking on a hob with fat or oil can be dangerous and may result in fire. NEVER try to extinguish a fire with water, but switch off the appliance and then cover flame e.g. with a lid or a fire blanket.
SAFETY INSTRUCTIONS Installation WARNING! Only a qualified person must install this appliance. WARNING! Risk of injury or damage to the appliance. • Remove all the packaging. • Do not install or use a damaged appliance. • Follow the installation instructions supplied with the appliance. • Keep the minimum distance from other appliances and units. • Always take care when moving the appliance as it is heavy. Always use safety gloves and enclosed footwear.
disconnect the appliance from the mains at all poles. The isolation device must have a contact opening width of minimum 3 mm. Use WARNING! Risk of injury, burns and electric shock. • Remove all the packaging, labelling and protective film (if applicable) before first use. • Use this appliance in a household environment. • Do not change the specification of this appliance. • Make sure that the ventilation openings are not blocked. • Do not let the appliance stay unattended during operation.
Service • Contact your municipal authority for information on how to discard the appliance correctly. • Disconnect the appliance from the mains supply. • Cut off the mains electrical cable close to the appliance and dispose of it. • To repair the appliance contact an Authorised Service Centre. • Use original spare parts only. Disposal WARNING! Risk of injury or suffocation.
Sensor field Function Comment Flexi4Zone To switch between three modes of the func‐ tion. - Heat setting display To show the heat setting. - Timer indicators of cooking zones To show for which zone you set the time. - Timer display To show the time in minutes. Auto-Vent To activate and deactivate the manual mode of the function. Control bar To set a heat setting. - To select the cooking zone. - To increase or decrease the time.
Eco-Heat (3 step Residual heat indicator) WARNING! / / There is a risk of burns from residual heat. The indicators show the level of the residual heat for the cooking zones you are currently using. The indicators may also come on for the neighbouring cooking zones even if you are not using them. The induction cooking zones produce the heat necessary for the cooking process directly in the bottom of the cookware. The glass ceramic is heated by the heat of the cookware.
Accelerator Activate this function to get a desired heat setting in a shorter time. When it is on, the zone operates on the highest setting in the beginning and then continues to cook at the desired heating setting. To activate the function the cooking zone must be cold. To activate the function for a cooking zone: touch the end of the control bar on the right ( comes on). Immediately touch a desired heat setting. After 3 seconds comes on. To deactivate the function: change the heat setting.
cooking zones do not operate. The heat setting display shows . the hob with again. To activate the function: touch . Touch or of the timer to set the time. When the time comes to an end, the sound operates and 00 flashes. OffSound Control (Deactivating and activating the sounds) To stop the sound: touch . The function has no effect on the operation of the cooking zones. Lock You can lock the control panel while cooking zones operate. It prevents an accidental change of the heat setting.
• P 60 — 6000 W CAUTION! Make sure that the selected power fits to the house installation fuses. Eco-Logic • Cooking zones are grouped according to the location and number of the phases in the hob. See the illustration. • Each phase has a maximum electricity loading of 3600 W. • The function divides the power between cooking zones connected to the same phase. • The function activates when the total electricity loading of the cooking zones connected to a single phase exceeds 3600 W.
Auto‐ matic light Boil‐ Fry‐ ing1) ing2) On Fan speed 1 Fan speed 1 Mode H3 On Off Fan speed 1 Mode H4 On Fan speed 1 Fan speed 1 Mode H5 On Fan speed 1 Fan speed 2 Mode H6 On Fan speed 2 Fan speed 3 Mode H2 3) 1) The hob detects the boiling process and activates fan speed in accordance with automatic mode. 2) The hob detects the frying process and activates fan speed in accordance with automatic mode.
different size, or into one large cooking area. You choose the combination of the sections by choosing the mode applicable to the size of the cookware you want to use. There are three modes: Standard (activated automatically when you activate the hob), Big mode and Max mode. To set the heat setting use two left side control bars. Switching between the modes To switch between the modes use sensor field: .
Incorrect cookware position: Incorrect cookware position: Flexi4Zone big mode To activate the mode press until you see the correct mode indicator . This mode connects three rear sections into one cooking zone. The one front section is not connected and operates as a separate cooking zone. You can set the heat setting for each zone separately. Use two left side control bars. Flexi4Zone max mode To activate the mode press until you see the correct mode indicator .
General information: Incorrect cookware position: • 160 mm is the minimum bottom diameter of the cookware for this function. • Heat setting display for the left rear control bar shows the position of the cookware on the induction cooking area. Front , middle , rear . Flexi-Heat This function allows you to adjust the temperature by moving the cookware to a different position on the induction cooking area. The function divides the induction cooking area into three areas with different heat settings.
remember your heat settings next time you activate the function. Activating the function To activate the function place the cookware in the correct position on the cooking area. Touch . The indicator above the symbol comes on. If you do not place the cookware on the cooking area comes on and after 2 minutes the flexible induction cooking area is set to . Deactivating the function To deactivate the function touch or set the heat setting to . The indicator above goes off.
increase of the consumption of power. It means that a cooking zone with the medium heat setting uses less than a half of its power. The data in the table is for guidance only. Heat setting Use to: Time (min) Hints 1 Keep cooked food warm. as nec‐ essary Put a lid on the cookware. 1-3 Hollandaise sauce, melt: but‐ ter, chocolate, gelatine. 5 - 25 Mix from time to time. 1-3 Solidify: fluffy omelettes, baked eggs. 10 40 Cook with a lid on.
Other remotely controlled appliances may block the signal. Do not use any remotely controlled appliances at the time when you use the function on the hob. Cooker hoods with the Auto-Vent function To find the full range of cooker hoods which work with this function refer to our consumer website. CARE AND CLEANING WARNING! Refer to Safety chapters. General information • Clean the hob after each use. • Always use cookware with a clean base.
What to do if... Problem Possible cause Remedy You cannot activate or oper‐ ate the hob. The hob is not connected to an electrical supply or it is connected incorrectly. Check if the hob is correctly connected to the electrical supply. Refer to the connec‐ tion diagram. The fuse is blown. Make sure that the fuse is the cause of the malfunc‐ tion. If the fuse is blown again and again, contact a qualified electrician. You do not set the heat set‐ ting for 10 seconds.
Problem Possible cause Remedy There is no sound when you touch the panel sensor fields. The sounds are deactivated. Activate the sounds. Refer to "Daily use". The flexible induction cook‐ ing area does not heat up the cookware. The cookware is in a wrong position on the flexible in‐ duction cooking area. Place the cookware in the correct position on the flexi‐ ble induction cooking area. The position of the cook‐ ware depends on the activa‐ ted function or function mode.
Problem and a number come on. Possible cause Remedy There is an error in the hob. Deactivate the hob and acti‐ vate it again after 30 sec‐ onds. If comes on again, disconnect the hob from the electrical supply. After 30 seconds, connect the hob again. If the problem contin‐ ues, speak to an Authorised Service Centre. You can hear a constant beep noise. The electrical connection is incorrect. If you cannot find a solution...
Cable cross section 230V~ 400V 2~N N N L1 L L2 One-phase connection - 230 V~ Two-phase connection - 400 V 2 ~ N Green - yellow Green - yellow N Blue and blue Blue and blue N L Black and brown Black L1 Brown L2 Assembly R 5mm min. 500mm min. 50mm min.
min. 28 mm min. 60mm min. 12 mm If the appliance is installed above a drawer, the hob ventilation can warm up the items stored in the drawer during the cooking process. TECHNICAL DATA Rating plate Model SI1F7645B Typ 62 B4A 05 AD Induction 7.2 kW Ser.Nr. ................. SMEG PNC 949 594 460 00 220 - 240 V / 400 V 2N 50 - 60 Hz Made in Germany 7.
Cooking zones specification Cooking zone Nominal pow‐ er (maximum heat setting) [W] Power func‐ tion [W] Power func‐ tion maximum duration [min] Cookware di‐ ameter [mm] Right front 1400 2500 4 125 - 145 Right rear 1800 2800 10 145 - 180 Flexible induc‐ tion cooking area 2300 3200 10 minimum 100 The power of the cooking zones can be different in some small range from the data in the table. It changes with the material and dimensions of the cookware.
• When you heat up water, use only the amount you need. • If it is possible, always put the lids on the cookware. • Before you activate the cooking zone put the cookware on it. • Put the smaller cookware on the smaller cooking zones. • Put the cookware directly in the centre of the cooking zone. • Use the residual heat to keep the food warm or to melt it. ENVIRONMENTAL CONCERNS Recycle materials with the symbol . Put the packaging in relevant containers to recycle it.
867349064-A-132018