User manual

90 - CLEANING AND MAINTENANCE 914779559/C
Removing racks/trays support frames
Removing the rack/tray support frames enables
the sides to be cleaned more easily.
To remove the rack/tray support frames:
• Pull the frame towards the inside of the oven
cavity to unhook it from its groove A, then
slide it out of the seats B at the back.
• When cleaning is complete, repeat the
above procedures to put the rack/tray
support frames back in.
Special cleaning functions
• From position 0, turn the function knob to the
left by one position. The button flashes.
Vapor Clean (on some models only)
Preliminary operations
Before starting the Vapo r Clean:
• Remove all accessories from inside the oven
cavity.
• Remove the temperature probe (where
fitted).
• Remove the self-cleaning panels (where
fitted).
• Close the door.
• During the assisted cleaning cycle, wash the
self-cleaning panels (where fitted), which
were previously removed, separately in
warm water and a small amount of
detergent.
Vapor Clean cycle setting
1. After entering the special functions menu,
press the button until the
function is selected.
2. Press the button to confirm.
3. Fill the tank with clean water until the full
load indicator light displays.
4. At the end, remove the funnel and place the
loading drawer back in its place.
The words and the button
flash to indicate that the function can be started.
5.
See General safety instructions.
The Vapor Clean function is an assisted
cleaning procedure which facilitates the
removal of dirt. Thanks to this process, it
is possible to clean the inside of the
oven very easily. The dirt residues are
softened by the heat and water vapour
for easier removal afterwards.
If the indoor temperature is higher than
expected, the function is not activated
and every time the button is
pressed the appliance makes a beep.
Let the appliance cool down before
activating the function.