Instruction manual

96 - CLEANING AND MAINTENANCE 914779671/E
2. Place the deep pan on the third shelf from
the bottom. Push it against the rear wall of
the oven cavity.
3. Press the button again to start the
function.
The descaling solution starts to flow into the
deep pan from the drain pipe on the right side
of the rear wall of the oven cavity.
4. Wait for the end of the drain flow.
At the end an acoustic signal sounds and the
display shows .
5. Drain the descaling solution from the deep
pan.
Rinse
Once the descaling agent has been drained,
the hydraulic circuit must be rinsed with clean
water.
The display will show the request to fill the
reservoir with water.
1. Open the door.
2. Place the deep pan on the third shelf from
the bottom. Push the tray up against the rear
wall of the oven cavity.
3. Pull the filling drawer out of its housing.
4. Insert the funnel provided in the filling
drawer.
5. Pour one litre of water using a bottle or a
measuring jug.
6. Press the button to start the function
and wait one minute.
At the end, the appliance sounds an acoustic
signal and the display shows the request to
drain the reservoir (the indicator light
comes on).
7. Press the button again to start the
function.
8. Wait for the end of the drain flow.
At the end an acoustic signal sounds and the
display shows .
9. Drain the water from the deep pan.
The display shows the new request to fill the
reservoir with water.
10 Place the deep pan on the third shelf from
the bottom. Push it against the rear wall of
the oven cavity.
11.Pour one litre of water into the funnel placed
in the filling drawer (using a bottle or a
graduated jug) until it has overflown to the
bottom of the cavity.
12. Press the button to start the function
and wait one minute.
At the end, the appliance sounds an acoustic
signal and the display shows the request to
drain the reservoir (the indicator light
comes on).
13.Press button again to drain the water
from the reservoir into the deep pan.
14.Wait for the end of the drain flow.
At the end an acoustic signal sounds and the
display shows .
15. Drain the water from the deep pan.
16. Return the function knob to the 0 position.
Sanitization
Sanitization with steam allows to remove the last
residues of descaling from the hydraulic circuit.
Take care: the descaling solution may
be still hot.
Use cold tap water which is not too
hard, softened water or still mineral
water.
Do not use distilled water, tap water
with a high chloride content (> 40 mg/
l), or other liquids.
The overflowing of water inside the
oven cavity is not intended as a
malfunction, rather it is part of the rinsing
procedure.