Instruction manual

CLEANING AND MAINTENANCE - 3191477A548/A
e
• Pour approx. 120 cc of water onto the floor
of the oven. Make sure it does not overflow
out of the cavity.
• Spray a water and washing up liquid
solution inside the oven using a spray
nozzle. Direct the spray towards the side
walls, upwards, downwards and towards
the deflector.
• Close the door.
• During the assisted cleaning cycle, wash the
self-cleaning panels (where fitted), which
were previously removed, separately in
warm water and a small amount of
detergent.
Vapor Clean cycle setting
1. After entering the special functions menu,
press the and touch buttons on
the control panel until the function is
selected.
2. Press the button to confirm.
3. Press the button to start the function.
At the end, is displayed and flashes
and a beep is activated.
4. Press the touch button on the control
panel to exit the function.
Programmed Vapor Clean cycle
It is possible to program the Vapor Clean
function start time, like any cooking function.
1. After selecting the Vapor Clean function,
press the button.
The indicator light flashes on the display.
2. Press the and touch buttons on
the control panel to set the function end time.
3. Press the button to confirm.
The appliance waits until the set start time to start
the Vapour Clean function.
End of Vapor Clean
1. Press the touch button on the control
panel to exit the function.
2. Open the door and wipe away the less
stubborn dirt with a microfibre cloth.
3. Use a non-scratch sponge with brass
filaments on hard to remove deposits.
4. In case of grease residues use specific oven
cleaning products.
5. Remove any remaining water from the oven
cavity.
6. Where fitted, reposition the self-cleaning
panels and the rack/tray support frames.
We recommend spraying approx. 20
times at the most.
Do not spray the deflector if it has a self-
cleaning coating.
If the indoor temperature is higher than
expected, the function is not activated
and every time the button is
pressed the appliance makes a beep.
Let the appliance cool down before
activating the function.
The duration and temperature
parameters cannot be changed by the
user.