User manual

Installation
25
EN
5. Replace the nozzle using a 7mm socket
wrench.
6. After having replaced the nozzle, put the
burner back in its seat.
7. Tighten the burner fastening screws.
8. Replace the shelf in its seat.
Minimum adjustment for propane
gas:
Turn off the burners and unplug the
appliance from the electric power supply.
To regulate the minimum flame for propane,
turn the screws at the side of the tap rod
fully clockwise. Once the regulation has
been completed, replace the seal on the
by-passes using paint or similar materials.
Check the appearance of the flames
• Yellow flames: Further adjustment is
required.
• Yellow tips on outer cones: Normal for
propane gas.
• Soft blue flames: Normal for Natural
Gas.
• Orange flames: Can be normal if certain
types of humidifiers are used in the
home. Flames should return to blue
without the humidifier running.
If the flame is completely or mostly yellow,
verify that the regulator is set for the correct
fuel. Retest after adjustment.
Some yellow streaking is normal during the
initial startup. Allow the appliance to
operate for 4–5 minutes and reevaluate
before making adjustments.
The tightening torque of the nozzle
must be 4 Nm.
Take care not to damage the
thermocouple or the igniter when
doing this.