User manual

Use
22
2.3 Using the cooktop
All the appliance's control and monitoring
devices are located together on the front
panel. The burner controlled by each knob
is shown next to the knob. The appliance is
equipped with an electronic ignition device.
Simply press the knob and turn it counter-
clockwise to the maximum flame symbol
until the burner lights. If the burner does not
light in the first 15 seconds, turn the knob to
and wait 5 minutes before trying
again.
After lighting, keep the knob pressed in for
a few seconds to allow the thermocouple to
heat up. The burner may go out when the
knob is released: in this case, the
thermocouple has not heated up sufficiently.
Wait a few moments and repeat the
operation. Keep the knob pressed in
longer.
To operate the cooktop burners
1. Press and turn the knobs counter-
clockwise to the value to light the
relative burners.
2. Turn the knobs to the zone between
and to adjust the flame.
3. Return the knobs to the position
to turn off the burners.
WARNING
Fire Hazard
• For your safety: do not allow the burner
flame to extend beyond the edge of the
pan.
• Turn off all controls when the cooktop is
not in use.
NOTE: If it is turned off by
accident, a safety device will trip,
shutting off the gas supply, even if
the gas tap is open. Return the
knob to and wait at least
5 minutes before lighting it again.