User manual

Cleaning and Maintenance
36
Removal of the rack/tray supports
Removing the guide frames makes it easier
to clean the sides of the oven. This must be
done each time you use the automatic
cleaning cycle (only on some models).
To remove the guide frames:
• Pull the frame towards the inside of the
oven to unhook it from its housing A, and
then slide it out of the grooves at the
back B.
• When you have finished cleaning the
oven, repeat the procedures indicated
above in reverse to replace the guide
frames.
3.5 Special maintenance
Seal maintenance tips
The seal should be soft and elastic.
• To clean the seal, use a non-abrasive
sponge and wash with lukewarm water.
Replacing the internal light bulb
1. Completely remove all accessories from
inside the oven.
2. Remove the rack/tray supports.
3. Use a tool (e.g. a spoon) to remove the
bulb cover.
WARNING
Danger of electrocution
• Unplug the appliance.
• Use protective gloves.
NOTE: The oven is fitted with one
40W light bulb.
NOTE: Pay attention not to scratch
the oven cavity enamel.