Operation Manual

User instructions
12
These products
are not suitable
for use with
excessively “hard”
water.
If the hardness level set is higher than H3, when the option is activated
the relative light flashes to indicate that the product is being used
incorrectly; the dishwasher will still work, but washing results may be
poor.
HYCLEAN
Prolongs the final hot rinse to ensure a further reduction in the bacteria
level. If the temperature in the tank falls during this stage of the program
(e.g. because the door is opened or due to a power cut), the option light
an program lights (2) flash to warn that this additional wash phase has
not been completed successfully. This does not mean that the wash
program has been less effective than usual.
PROGRAM DELAY
The start of the washing program can be delayed by from 1 to 24 hours
depending on the model, to program the dishwasher to operate at the
preferred time of day (e.g. overnight).
● It is not possible to select the option once the cycle has begun.
● When the door is closed, the appliance will prewash the dishes, after
which the count of the "program delay" set will begin.
Models without display
The start of the program can be delayed by 3,
6 or 9 hours. The button can be pressed
again to select the delay required (the
relative light comes on) or disable the option
(lights off).
Models with display
The button can be pressed again to select
the delay required, increasing it in one-
hour steps, with the duration shown on the
display.