Instruction manual

Installation
10
2.2 General Information

This appliance may be placed up against walls or
other furniture units.

If the appliance is installed near a heat source, fit a
special insulating panel to prevent overheating and
malfunction of the appliance.

To facilitate the installation procedure, the intake and
drain hoses can be positioned in any d
irection; make
sure that the hoses are not kinked, crushed or pulled
too tightly.

A hole at least 8 cm in diameter is required to allow
the power supply cable and hoses to pass.

At the end of the installation, perform a short test of
the appliance: open th
e water tap and check that
there are no leaks.

To install the dishwasher against the back wall, the
hoses should be passed through the lower area
where there is a dedicated space for them.
Level the appliance on the floor using the
appropriate Allen ke
y to regulate the adjustable
feet. This operation is essential for ensuring
correct operation of the dishwasher.
Some models are equipped with only one
adjustable foot at the rear, which can be adjusted
by turning the screw on the lower front part
of the
appliance.