User manual

ManualsBrandsSmeg ManualsCooking centersClassica Cooking Centers

PRECAUTIONS - 391477A242/A

PRECAUTIONS 3

General safety instructions 3

Installation 7

Appliance purpose 8

This user manual 8

Manufacturer’s liability 8

Identification plate 8

Disposal 8

Information for European Control Bodies 9

Energy efficiency technical data 9

To save energy 9

Light sources 9

How to read the user manual 9

DESCRIPTION 10

General description 10

Hob 10

Control panel 11

Other parts 12

Accessories 12

USE 13

Preliminary operations 13

Using the accessories 13

Using the hob 14

Using the storage compartment (where present) 16

Using the oven 16

Digital programmer 17

Cooking advice 19

Cooking information table (multifunction oven) 20

Cooking information table (auxiliary oven) 21

Cooking information table (vertical oven) 21

CLEANING AND MAINTENANCE 22

Cleaning the appliance 22

Cleaning the glass ceramic hob 22

Knobs 23

Cleaning the door 23

Cleaning the oven cavity 24

Cleaning the roof of the oven (only for some

models/cavities) 25

Vapor Clean (on some models only) 25

Extraordinary maintenance 26

INSTALLATION 27

Positioning 27

Electrical connection 28

Instructions for the installer 29

We advise you to read this manual carefully, which contains all the instructions for maintaining the

appliance’s aesthetic and functional qualities. For further information on the product: www.smeg.com

PRECAUTIONS

General safety instructions

Risk of personal injury

• During use the appliance and

its accessible parts become

very hot. Keep children well

away from the appliance.

• The appliance becomes very

hot during use. Make sure that

you never touch the heating

elements inside the oven.

• Protect your hands by wearing

oven gloves when moving food

inside the oven.

• Never try to put out a fire or

flames with water: Turn off the

appliance and smother the

flames with a fire blanket or

other appropriate cover.

• This appliance may only be

used by children aged 8 years

and over, and by people of

reduced physical, sensory or

mental capacity, or lacking in

experience in the use of

electrical appliances, provided

that they are supervised or

have been given instructions on

the safe use of the appliance

and of the hazards associated

with it.

• Children must not play with the

Summary of content (27 pages)

PAGE 1
PRECAUTIONS 3 General safety instructions Installation Appliance purpose This user manual Manufacturer’s liability Identification plate Disposal Information for European Control Bodies Energy efficiency technical data To save energy Light sources How to read the user manual 3 7 8 8 8 8 8 9 9 9 9 9 DESCRIPTION 10 General description Hob Control panel Other parts Accessories 10 10 11 12 12 USE 13 Preliminary operations Using the accessories 13 13 Using the hob Using the storage compartment (where
PAGE 2
• • • • • • • • • appliance. Keep children under the age of eight at a safe distance unless they are constantly supervised. Keep children under the age of 8 away from the appliance when it is in use. Cleaning and maintenance must not be carried out by unsupervised children. Be aware of how rapidly the cooking zones heat up. Do not place empty pans on the heat. Danger of overheating. After use the cooking zones remain hot for a certain period of time after they have been turned off.
PAGE 3
• • • • • • • • • USE. DO NOT MODIFY THIS APPLIANCE. Always wear personal protective equipment (PPE) before carrying out any work on the appliance (installation, maintenance, positioning or moving). Do not clean the appliance if it is still hot or in operation. Before performing any work on the appliance, switch off the power supply.
PAGE 4
• • • • • • • door of the oven since they may scratch the surface and cause the glass to shatter. Use wooden or plastic utensils. Do not use steam jets to clean the appliance. Do not use the appliance as a support surface. Do not obstruct ventilation openings and heat dispersal slots. Do not sit on the appliance. Do not rest any weight or sit on the open door of the appliance. Racks and trays should be inserted as far as they will go into the side guides.
PAGE 5
• • • • • • • • • • mixtures on the hob during cooking. Do not place materials or substances that could melt or catch fire (paper, plastic or aluminium foil) on the appliance while it is in use. Do not use steam jets to clean the appliance. Place the cookware directly on the glass ceramic surface. Do not put empty pans or frying pans on switched on cooking zones. Do not use rough or abrasive materials or sharp metal scrapers.
PAGE 6
• • • • • • • • system safety standards. Use cables that can withstand temperatures of at least 90°C. The tightening torque of the screws of the terminal supply wires must be 1.5 - 2 Nm. Be careful when connecting additional electrical appliances. Connection cables must not come into contact with hot cooking zones. The power cable must only be installed or replaced by a qualified technician.
PAGE 7
other waste at the end of its service life. The appliance does not contain substances in quantities sufficient to be considered hazardous to health and the environment, in accordance with current European directives. • Power voltage Danger of electrocution • • Disconnect the mains power supply. • • Unplug the appliance. • To dispose of the appliance: • Cut the power cable and remove it.
PAGE 8
DESCRIPTION General description 1 2 3 4 5 6 7 8 9 10 11 12 13 Hob Control panel Auxiliary oven light Auxiliary oven seal Auxiliary oven door Multifunction oven light Multifunction oven door Multifunction oven seal Fan Vertical oven seal Vertical oven door Vertical oven light Vertical oven fans Frame shelf Hob Zone 1 Dimensions H x L Pan minimum Ø (mm) (mm) 210 x 210 10 - DESCRIPTION 120 Pan Ø shelf (mm) 210 Power draw in Max.
PAGE 9
Zone Dimensions H x L Pan minimum Ø (mm) (mm) Pan Ø shelf (mm) Power draw in Max. power draw Booster function (W)* (W)* 2 180 x 180 110 180 1300 1400 3 270 x 270 145 270 2300 3000 4 180 x 180 110 180 1300 1400 5 210 x 210 120 210 2300 3000 * power levels are indicative and can vary according to the pan used or the settings made. Advantages of induction cooking The appliance is equipped with an induction generator for each cooking zone.
PAGE 10
4 Auxiliary oven variable grill indicator light The indicator light comes on to indicate that the auxiliary oven is heating up. It turns off as soon as it reaches the set temperature. It flashes regularly to indicate that the temperature set inside the oven is kept constant. 5 Left multifunction oven left temperature knob This knob allows you to select the cooking temperature and the Vapor Clean temperature. Turn the knob clockwise to the required value, between the minimum and maximum setting.
PAGE 11
Rack during cooking. Plate rack Useful for supporting containers with food during cooking. Vertical oven rack Used for warming plates. Useful for supporting containers with food USE Preliminary operations See General safety instructions. • Remove any protective film from the outside or inside of the appliance, including accessories. • Remove any labels (apart from the technical data plate) from the accessories and shelves.
PAGE 12
the food which is being cooked. Plate rack 1. Insert the plate rack without plates in the first shelf of the side oven. 2. Position the plates as shown in the figure. surface must be made of metal, with magnetic properties and a sufficiently large base. Suitable cookware: • Enamelled steel cookware with thick bases. • Cast iron cookware with an enamelled base. • Cookware in multilayer stainless steel, ferritic stainless steel and aluminium with a special base.
PAGE 13
saucepan or frying pan on the cooking zone being smaller than the zone itself, only the necessary energy will be transmitted. Saucepan recognition limits The minimum diameter of the pan base is indicated by the cross on the cooking zone. Pans with smaller diameters risk not being detected and therefore not activating the inductor. Limiting the cooking duration The hob has an automatic device which limits the duration of use.
PAGE 14
Keep warm The Keep warm function allows you to keep cooked food warm. To activate the Keep Warm function turn the knob of the required zone to an intermediate position between 0 (off) and power level 1, until the symbol appears on the corresponding display. Hob power limitation The induction hob is configured to operate at 7.4 kW, but it can be set to operate at 4.8 kW or 3.7 kW. 1. Disconnect the appliance from the mains power supply and wait 10 seconds before turning the power back on.
PAGE 15
1. Select the cooking function using the function knob. 2. Select the temperature using the temperature knob. Make sure that the digital programmer shows the cooking duration symbol , otherwise it will not be possible to turn on the oven. Press the button to reset the programmer clock. List of traditional cooking functions Not all functions are available on some models. STATIC Traditional cooking, ideal for preparing a single dish. For example cooking roast meats, fatty meats, bread, pies.
PAGE 16
1. Hold down the clock button for two seconds. The dot between the hours and the minutes flashes. 2. The time can be set via the increase key and decrease key . Keep the button pressed to increase or decrease rapidly. 3. Wait 7 seconds. The dot between the hours and the minutes stops flashing. 4. The symbol on the display indicates that the appliance is ready to start cooking. To change the time, hold down the increase key and decrease key at the same time for two seconds, then set the time.
PAGE 17
12. Press the and buttons at the same time to reset the set program. It is not possible to set a cooking time of more than 10 hours. It is not possible to set a programmed cooking time of more than 24 hours. After setting, hold the clock key down for 2 seconds to display the cooking time remaining. Press the clock key again. The display shows the text and the remaining cooking time in sequence.
PAGE 18
the dough. • To check whether the dessert is cooked right through: At the end of the cooking time, put a toothpick into the highest point of the dessert. If the dough does not stick to the toothpick, the dessert is cooked. • If the dessert collapses when it comes out of the oven, on the next occasion reduce the set temperature by about 10°C, selecting a longer cooking time if necessary.
PAGE 19
Food Weight (Kg) Function Shelf Temp. Time (°C) (minutes) Monkfish 1.5 CIRCULAIRE 2 160-170 60 - 65 Turbot 1.5 CIRCULAIRE 2 160-170 45 - 50 Pizza 1 FAN ASSISTED 2 260 8-9 Bread 1 CIRCULAIRE 2 190 - 200 25 - 30 Focaccia 1 CIRCULAIRE 2 180 - 190 20 - 25 Bundt cake 1 CIRCULAIRE 2 160 55 - 60 Tart 1 STATIC 2 170 30 - 40 Ricotta cake 1 CIRCULAIRE 2 160 - 170 55 - 60 Jam tarts 1 CIRCULAIRE 2 160 20 - 25 Paradise cake 1.
PAGE 20
Food Focaccia Slices of toast Weight Function Shelf 0.5 x 4 CIRCULAIRE 2-4-6-8 (Kg) Temp. Time (°C) (minutes) 180 35 - 40 0.2 x 4 CIRCULAIRE 2-4-6-8 180 3-5 Brioches 4 per shelf CIRCULAIRE 2-4-6-8 160 30 - 35 Biscuits 0.2 x 4 CIRCULAIRE 2-4-6-8 160 20 - 23 1x4 CIRCULAIRE 2-4-6-8 160 60 Paradise cake The times indicated in the table do not include preheating times and are provided only as a guide.
PAGE 21
Knobs Do not use aggressive products containing alcohol or products for cleaning steel and glass when cleaning the knobs, as these products could cause permanent damage. that grooved sections A are resting completely in the slots. The knobs should be cleaned with a soft cloth dampened with lukewarm water, then dried carefully. They can be removed by pulling them out from their housings. Cleaning the door Cleaning the door glazing The glass in the door should always be kept thoroughly clean.
PAGE 22
4. Replace the internal glass panels after cleaning. Take care to centre and insert the 4 pins into their housings in the oven door by applying slight pressure. pins into their slots in the oven door by applying slight pressure. Cleaning the oven cavity Auxiliary oven door 1. Remove the internal glass panel by pulling the rear part gently upwards, following the movement indicated by the arrows (1). 2. Then, pull the front part upwards (2).
PAGE 23
slide it out of the seats B at the back. • When cleaning is complete, repeat the above procedures to put the rack/tray support frames back in. Removing the vertical oven rack/tray support frames Removing the rack/tray support frames enables the sides to be cleaned more easily. To remove the rack/tray support frames: • Pull the frame upwards to remove it from its side housings. 1. Free the upper heating element by gently lifting it and rotating its retaining latch by 90 degrees. 2.
PAGE 24
the deflector. We recommend spraying approx. 20 times at the most. Do not spray the deflector if it has a selfcleaning coating. • Close the door. • During the assisted cleaning cycle, wash the self-cleaning panels (where fitted), which were previously removed, separately in warm water and a small amount of detergent. Vapor Clean cycle setting 1. Turn the functions knob to symbol or (where present). 2. Turn the temperature knob to the symbol. 3. Allow the cleaning cycle to run for 18 minutes.
PAGE 25
6. Refit the cover. Ensure the moulded part of the glass (A) is facing the door. 7. Press the cover completely down so that it attaches perfectly to the bulb support. INSTALLATION The appliance must be installed by a qualified technician and according to the regulations in force. Appliance overall dimensions L Positioning C B A H I C See General safety instructions.
PAGE 26
3. Align the slots of the upstand (B) with the screws (A). Appliance dimensions The upstand provided is an integral part of the product. It must be fastened to the appliance prior to installation. Mounting the plinth Position of electrical connection Levelling the appliance The plinth must always be positioned and secured correctly on the appliance. 1. Place the plinth in the front bottom part of the appliance. 2. Screw the two side screws to fasten the plinth to the appliance. 3.
PAGE 27
The appliance can work in the following modes: 220-240 V 2~ 3 x 10 mm ² three-core cable 220-240 V 3~ 4 x 6 mm ² four-core cable 220-240 V 1N~ 3 x 10 mm ² three-core cable 380-415 V 2N~ 4 x 6 mm ² four-core cable For the Australian/New Zealand market: The circuit breaker incorporated in the fixed connection must comply with AS/NZS 3000. Instructions for the installer • If you use a plug (if present) to connect to the power supply, the plug must be accessible after installation.