Technical data

Instructions for the installer

• Use H05V2V2-F cables resistant to at least 90°C.

• The values indicated above refer to the cross-section of the internal conductor.

• The tightening torque of the screws of the terminal supply wires must be 1.5 - 2 Nm.

• The aforementioned power cables are sized taking into account the coincidence factor (in compliance

with standard EN 60335-2-6).

11.6 Positioning the skirt (on some models only)

WARNING: The skirt provided is an integral part of the product; it must be fastened to the

appliance prior to installation.

The skirt must always be positioned and secured correctly on

the appliance.

1 Loosen the 4 screws (A) on the back of the worktop (2 for

each side).

2 Place the skirt above the worktop, taking care to align the

skirt's slots (B) with the screws (A).

3 Secure the skirt to the worktop by tightening screws (A).

11.7 Positioning and levelling the appliance

After making the electrical and/or gas connections, level the

appliance on the floor by means of its four adjustable feet. The

appliance must be properly levelled to ensure stability.