Troubleshooting guide

142468
Prior to any cleaning. Please disconnect the
appliance from the mains (turn the thermostat
button to the position
and pull the power cord from
the mains outlet). Special antibacterial protection in
top layer of inner walls prevents growth of bacteria
and maintains the interior clean and germ free. Make
sure to remove traces of any cleaning agents you had
been using.
•
To clean any surface, use a soft cloth.
•
Clean the exterior of the appliance with water and
mild liquid detergent.
•
For cleaning of plastic, coated, or aluminum parts
avoid using abrasive or special cleansing agents
(like the stainless steel polish), otherwise you may
damage the surface.
•
Clean coated and aluminum surfaces using the soft
cloth and alcohol based cleaning agent (like glass
cleaner).
•
Wash the interior of the appliance with mild liquid
detergent and lukewarm water, mixed with a little
vinegar.
•
Groove and drain outlet located below the cooling
panel at the rear wall collect the drained water, so
should not be clogged (e.g. with food particles).
Make sure you inspect them periodically and clean if
necessary (use plastic straw to free the outlet hole).
•
The condenser on the rear wall must always be
clean and free of dust or kitchen fumes deposits,
therefore clean the dust periodically with non-
metallic brush or vacuum cleaner.
•
Clean also the drip pan above the compressor.
If you removed the pan, please make sure you
replace it to the same position, and check that it is in
completely horizontal position!
•
Ice and/or frost deposits exceeding 3-5 mm increase
energy consumption, so should be defrosted
regularly (not for the NO FROST freezer). Do not
use sharp pointed objects, solvents or sprays.
•
After cleaning switch the appliance on and reload
the food.
29
Cleaning