REFRIGERATOR/FREEZER UPRIGHT UKFC36RX2 / UKFC40RX3
Please read these instructions carefully before putting the appliance into service. They are brief and contain only information which will help you to obtain the best performance from the appliance. Take care of all accessories supplied with the appliance. CONTENTS 1. Before starting the refrigerator/freezer. 2. How to use the appliance. 3. General advice on the use of the appliance. 4. Maintenance. 5. Has the appliance stopped working? 6. Safety. 7. Technical data. 8. Installation. 9.
1. BEFORE STARTING THE REFRIGERATOR/FREEZER Check that the cabinet is undamaged. Please report any transport damage immediately to your dealer. Wash the cabinet and inner lining with a mild unscented detergent and wipe it dry. Do not use abrasive scouring powder, steel wool or similar. Connection to the electricity supply: See head (7) and (8). 2. HOW TO USE THE APPLIANCE Operating panel: See fig. (1) page 7. 1. Lamp for the refrigerator section. 2. Thermostat knob for the refrigerator section. 3.
Fold out the draining spout, mount the enclosed extension and place a bowl under it, fig. (3) page 7. Wipe the cabinet when the frost has disappeared. 3. GENERAL ADVICE ON THE USE OF THE APPLIANCE The shelves in the refrigerator section can be moved, fig. (5) page 7. The door rack and the butter- and cheeseboxes are also movable, fig. (2) page 7. The freezing shelf cover should be closed. The covers are opened by pulling, fig. (6) page 7. To remove the baskets lift them over the stop pins, fig. (4) page 7.
7. TECHNICAL DATA This appliance meets the provisions of the following directives: 89/336/EEC (electromagnetic compatibility), 73/23/EEC (electrical equipment designed for use within certain voltage limits) as amended. Household appliances sold in the EU also meet 96/57/EEC (energy efficiency requirements) as amended. The rating plate, which is placed either at the back or inside the appliance, see fig. (7) page 7, provides various technical information as well as type and serial number.
Adjusting the door If the door bumps against the bottom panel, this can be remedied by adjusting the feet as shown on the drawing. Fig 1. 600 600 Side by side Concerns all fridge/freezer models: If 2 appliances are to be placed side by side, the minimum distance between these must be 30 mm. The distance to other sources of heat must also be at least 30 mm. 50 50 50 Fig 2.
4 8 6 ! S 7 1 0 0 Fig 2. Fig 4. Fig 6. 0 1 7 2 6 2 6 5 Fig 1. 2 1 7 ..-10.....-20.....-30.. S 3 3 4 5 3 4 5 Fig 3. Fig 5. Fig 7.
9. CHANGE OF HINGE SIDE 1) Dismantle the top hinge. This one is to be used later as top hinge at the opposite side. Lift off the top door. 5) Dismantle the screws in the middle of the new hinge side. Mount the bottom door and screw on the middle hinge. 6) 2) On appliances with a door closer on the upper door, this door closer should be removed and remounted on the opposite side. Adjusting the bottom door: Loosen the 3 screws in the bottom hinge and push the bottom hinge to the required side.
« ¿ » ƒ » ¡ ¬ √ ≈ Δ 9