INTEGRATED WASHER DRYER INSTRUCTION MANUAL GB 1
GB Contents 1. The new washing system 3 2. Saf ety warnings 4 3. Installation instructions 6 4. Description of controls 12 5. Washing instructions 17 6. Drying instructions 22 7. Cleaning and maintenance 26 8. Troubleshooting 28 9. Control panel symbols 30 This appliance is marked according to the European directiv e 2002/96/EC on Waste Electrical and Electronic Equipment WEEE).
GB 1. THE NEW WASHING SYSTEM This new washer dryer is the outcome of years of research. The leading-edge design and the quality of the production processes used to manufacture this product ensure it will give you many years of excellent service. Its concept satisfies all current and future washing and drying requirements. Its low water, power and detergent consumption help protect the environment and reduce running costs to a minimum. Water and power consumption has been reduced in all programmes.
GB 2. SAFETY WARNINGS Attention! These w arnings are given for safety reasons. Please read them carefully before installing and using the appliance. This manual forms an integral part of the appliance and must therefore be kept intact together with the machine. Before using the appliance, carefully read all the instructions contained in this manual. Installation must be performed by a qualified technician in compliance with the regulations in force.
GB Do not wash petrol-soaked garments in the washer dryer. Make sure there are no inflammable items (e.g.: lighters, matches, etc.) in pockets before washing. If volatile fluids have been used to clean garments, make sure that the substances have been removed before loading them in the washing machine. Before loading garments for washing, make sure the pockets are empty, the buttons securely fixed and the zips closed. Do not wash frayed or torn garments.
GB 3. INSTALLATION INSTRUCTIONS Important ! The appliance must be installed by a specialised technician according to current regulations. This washer dryer is very heavy. Take care when lifting it. 3.1 UNPACKING The inside of the machine comprises a mov ing assembly which is blocked f or transport purposes by the screws (A) located at the rear of the washer dryer. 1. 2. 3. Release the assembly by removing these screws with a 13 mm wrench.
GB 3.3 ADDITIONAL IMPORTANT INSTALLATION INSTRUCTIONS 1. 2. 3. Caref ully read the installation instructions in point 3 on page 6 of the washer dryer installation manual. After the initial instructions have been adhered to. I.e. remov ing transit bolts and fitting the adjustable feet etc. Using a spirit level, make sure that the washer dryer is completely lev el and the overall height of the legs, including the rubber foot and the locking nuts, is no greater than 25mm maximum.
GB 3.5 DRAIN CONNECTION 1. Insert the end of the drain hose into a drain pipe hav ing an internal diameter of at least 4 cm and a height ranging between 50 and 90 cm, or attach it (using the relative curv ed plastic prof ile) to a basin or bath tub. 2. Alway s check that the end of the drain hose is securely attached in order to prevent the repulsive f orce of the water f rom moving it out of position. Attention! • Do not bend or obstruct the hose as this will reduce the f low of water.
GB 3.7 FITTING T HE FURNIT URE DOORS Once the washer dry er has been correctly installed and commissioned, the f urniture door can be f itted following the dimensions on the template and the instruction enclosed in the washer dry er packaging. Please note that only f urniture doors of a thickness between 16mm and 21mm are compatible with this washer dry er. Important – The machine complies with the current safety provisions governing electrical equipment.
GB 3.7.2 Use of the furniture door fixing template Proceed in the following way when applying the wooden panel to the washing dryer: 1. 2. 3. 4. 5. 6. 7. 8. 3.7.3 1. 2. 3. When f itting the f urniture door utilising the door template y ou will need to make sure that the bottom and the top of the f urniture door will line up with the adjacent cabinet furniture doors.
GB 4. 5. 3.7.4 On the opposite side of the f urniture door either insert closing hook “B” or screw in metal plate “C” into the upper side opposite the hinges. Then insert the door buffer ”D” into the remaining position opposite the lower hinge Following this operation the f urniture door will be ready to be f itted onto the washer dryer using the 2 screws “A” supplied. Adjusting the hinges If the furniture door needs final adjustment the screws “A” can be slackened and the door lev elled.
GB 4. DESCRIPTION OF CONTROLS 4.1 CONTROL PANEL All the commands and controls of the appliance are assembled together on the f ront panel.
GB A Open door button Press the button to open the door. Chapter 5 – Washing instructions – explains how the door works and how to use it. B ON-OFF and w ashing and This knob lets you: • switch the machine on and off by moving it in either direction from the OFF position (knob indicator vertical) • select washing temperatures within the various fabric sectors by turning it in both directions • select the drying programme The knob does not move while the programme is running.
GB G Display The display shows the following information: 1. time remaining for the selected programme, given in hours/minutes. 2. delayed start (for models featuring this option). Given in hours/minutes. When the time remaining before the programme starts is less than 60 minutes, this information is given in minutes/seconds. 3. spin speed 4. drying times given in hours/minutes 5. cycle pause - flashing STOP 6. end of cycle - END 7.
GB M Options buttons The options that may be available on the washer dryer are shown below. Quick wash Button This button reduces the overall duration of the washing cycle. This option is used to wash small loads or less dirty washing in less time. The bleach stage is skipped when the Quick Wash button is pressed (for models with bleach function).
GB N Options enabled LED's These LED's light up when the relative option button is pressed and indicate that the option has been selected. They remain on until the machine switches off or a different selection is made. O “Start/Pause” button Press this button to start the selected washing programme. During washing, press the “Start/Pause” button for about 3 seconds to pause the washing cycle. During the pause, the “Time remaining” Led flashes and STOP appears on the display.
GB 5. WASHING INSTRUCTIONS 5.1 PREPARING THE WASHING 1. 2. Separate the washing according to the type and colourfastness of the fabrics. Wash whites and coloureds separately. Wash new coloured garments separately f or the f irst time. A label is normally applied to garments giv ing inf ormation on how to clean them. A brief description of these labels is shown below. W ASHING BLEACHING Machine wash at max. 90°C Machine wash at max. 60°C Do not bleach Bleachi ng allowed IRONING Machine wash at max.
GB 5.3 PREPARING THE WASHING Where possible, save electricity by washing full loads divided by type of fabric. Introduce loose washing and alternate large items with small ones. For the first f ew times, weigh the wash loads and then rely on y our judgement. Av erage weights of common garments are shown below: 5.4 LOADING T HE WASHING 1. 2. 3. 4.
GB 5.6 DOSING POWDER DET ERGENT S Normally dirty washing 1. Choose a programme without prewash. 2. Pour the total quantity of detergent indicated on the packs into compartment “2” of the detergent tray. Very dirty washing 1. Choose a programme with prewash. 2. Add ¼ of the recommended quantity of detergent into compartment “1” of the detergent tray and ¾ of the detergent into compartment “2”.
GB D isplay information U When the machine is switched on, the display visualises the duration (hours/minutes) and maximum spin speed env isaged f or the programme. These two parameters are display ed alternativ ely for 3 seconds each, together with their relative LED's, until the selected programme starts.
GB 5.11 STARTING THE WASHING PROGRAMME 1. Bef ore starting the selected programme, carefully close the door, open the water tap and add the detergent and additiv e 2. Press the “Start-Pause” button. The LED located above the Start-Pause button remains lit throughout the cy cle. After starting, the display shows the time remaining until the end of the programme. The LED remains on throughout the cycle.
GB To continue draining and spinning, press the spin select button twice. The machine resumes the cycle by draining the water and spinning. To select spin speed, press the button until the required speed is display ed. If you wish to drain the water in the tub without spinning, press the spin select button until 0000 appears on the display. This indicates that the machine will drain the water without spinning. 5.
GB • • • For automatic wash+dry programmes, theref ore, the dry ing temperature depends on which washing programme is selected. The washing must hav e been prev iously washed and spun bef ore a dry -only programme can be perf ormed. When dry ing particularly f luffy items such as new terry towels, the "Rinse" program should be carried out to ensure that any deposits left by the f abric are removed, and are not deposited on the clothes in the next wash.
GB Example 5. Dry ing times depend on the spin speed: the higher the speed the lower the drying time and, consequently, the lower the power consumption. Choose the highest spin speed compatible with the ty pe of washing. To start the washing programme, automatically f ollowed by the dry ing programme, follow the instructions shown in paragraph 5.11 – Starting the washing programme.
GB 6.5 INT ERRUPTING OR CHANGING T HE DRYING PROGRAMME 1. 2. To interrupt the dry ing programme, proceed as indicated in point 1 of paragraph 5.12 – Interrupting or changing the washing programme. When the machine is paused, the dry ing time can be changed by pressing the select button ( ). If you wish to stop the programme and remove the washing, y ou should f irst allow the appliance to cool. Set dry ing time to 20 minutes with the select button.
GB 7. CLEANING AND MAINTENANCE Important – Before cleaning or servicing the machine, remove the plug from the socket. 7.1 EXT ERNAL CL EANING • • • • • Regular and constant cleaning will keep y our appliance looking like new. Clean the outer surfaces with soap and water and then dry thoroughly with a soft cloth. Clean parts in plastic with a damp cloth. Do not scratch with sharp objects and do not use solv ents or abrasive products as these will damage the surf ace.
GB 3. Pull out the drain hose “A”. Attention: if the hose is hot it means the water is hot or boiling. Place a tray on the f loor and remov e the plug “B” to drain the water. Depending on the quantity of water, it may be necessary to empty the tray sev eral times. When no more water comes out, push the hose back in and screw back the plug “B”. 4. Unscrew the cov er of the pump “D” by turning it anti-clockwise. Clean the pump body and remov e any f oreign bodies.
GB 8. TROUBLESHOOTING This product complies with current saf ety regulations gov erning electrical equipment. For saf ety reasons, all technical inspections or repairs must be perf ormed by qualified technicians in order to prevent hazardous situations f or users. If the machine does not work, bef ore calling the Serv ice Centre and spending money unnecessarily, check that the operations indicated in this t roubleshooting table hav e been performed.
GB 11 The machine does not spin The unbalanced load sensor has triggered because the washing is not unif ormly distributed inside the drum. If the washing is wet at the end of the cycle, distribute it well inside the basket and repeat just the spin cycle. 12 Draining water from the drum In the event of a power f ailure or a fault in the appliance, the water inside the drum can be drained as described in paragraph 6.
GB 9.
Slightly dirty delicate coloureds 30° 4 - 2 Normally dirty delicate coloureds 40° 5 - 2 Normally dirty resistant coloureds 60° 5 - 2 Very dirty washing 60° 5 1 2 Extremely dirty washing 90° 4 1 Drain and spin 0° 5 Rinses 0° Fabric softener Max. drying load (kg) 2 Drying possible after washing Main wash detergent - Extra Rinse Prewash detergent 4 Description of washing cycle Quick wash Max.