Instructions / Assembly

1. Assemble Hose To Tank

IMPORTANT: Do not attempt to heat or alter

hose, hose nut, or barb prior to assembly.

1. Align hose barb tabs, push hose barb into tank

until it stops (See Figure A).

2. Slide hose nut into place and turn clockwise to

tighten. (See Figure B).

NOTE: Do not use tools to tighten hose nut.

Figure A Figure B

3. Assemble Shut-o to Wand

Screw on Wand Assembly to end of Shut-o

and tighten securely. (See Figure D)

Figure D

2. Assemble Wand & Nozzle

Place nozzle onto the end of the

wand assembly and tighten securely.

(See Figure C)

Conguration for

nozzle tip sprayers

Figure C

SETTING UP YOUR FOAMING

R200F SPRAYER

190456

PAGE 1
SETTING UP YOUR FOAMING R200F SPRAYER 190456 1. Assemble Hose To Tank IMPORTANT: Do not attempt to heat or alter hose, hose nut, or barb prior to assembly. 1. Align hose barb tabs, push hose barb into tank until it stops (See Figure A). 2. Slide hose nut into place and turn clockwise to tighten. (See Figure B). NOTE: Do not use tools to tighten hose nut. Figure A 2. Assemble Wand & Nozzle Place nozzle onto the end of the wand assembly and tighten securely.
PAGE 2
PARTS INCLUDED WITH YOUR FOAMING R200F SPRAYER 190456 181818 SHUT-OFF ASSEMBLY 182112 21” SS WAND ASSEMBLY 182187 HIGH FOAM NOZZLE 180097 NOZZLE TIP HIGH VOLUME (RED) 181822 ADJUSTABLE NOZZLE POLY 180168 NOZZLE TIP LOW VOLUME (YELLOW) 181812 NOZZLE FLAT SEAL CLEANING SCREEN HIGH-PERFORMANCE FOAMING NOZZLE KIT# 182196 ATTACHING HIGH-PERFORMANCE FOAMING NOZZLE TO WAND STEP 1 Unclip both sides of front cap and pull forward. STEP 1 STEP 2 Rinse to remove any debris from screen.