Manual

33
REMOVE / INSTALL INSIGHT
®
LASER CONT’D
• Remove the Contact
Cover from the back of the
Insight
®
Laser housing to
gain access to the batter-
ies (Figure A4).
INSTALL THE INSIGHT®
LASER ONTO THE BODY-
GUARD® 38 REVOLVER.
• Install two silver oxide bat-
teries as shown (Figure
A4). Proper battery orien-
tation is clearly marked on
the Insight
®
Laser housing.
• Reinstall the battery con-
tact cover by sliding it
under the edges of the
Insight
®
Laser housing as
shown (Figure A5).
• Insert the Insight
®
Laser
alignment pins (Figure A5)
into the corresponding
holes in the revolver’s
frame (Figure A6). Use the
provided hex wrench to
turn the hex screw clock-
wise until tight. Make sure
the Insight
®
Laser is
secured and cannot move
(Figure A7).
FIGURE A4
FIGURE A5
FIGURE A7
FIGURE A6
Battery contact cover goes under INSIGHT
®
Laser housing
edge
Alignment
Pins