Manual

LASER ADJUSTMENT & ZEROING CONT’D

NOTE: Direct sunlight may hinder the ability of the user to effective-

ly see the laser beam on the target.

• Mount a target with a clearly visible aiming point downrange at

the desired zeroing distance.

• Turn ON the Insight

Laser by pressing the push-button once.

• While aiming the BODYGUARD

38 with its iron sights, rotate

the adjustment screws as needed to superimpose the laser

strike point over the BODYGUARD

38’s aim point (FIGURE

A11). To determine the required direction of rotation, refer to the

Laser Adjustment Table on page 35.

• Direct the Insight

Laser at the target aiming point.

• Fire a 3-round shot group and note the center of the shot group

relative to the target aiming point.

• Rotate the adjustment screws as needed to move the center of

the shot group to the target aiming point. To determine the

required direction of rotation, refer to the Shot Group Movement

column in the Laser Adjustment Table on page 35.

• Fire another 3-round shot group to confirm zero.

• Repeat these steps until the shot group falls within an accept-

able radius around the target aim point.

The Insight

Laser is now zeroed to the BODYGUARD

38.

Press the push-button twice to turn the laser OFF.

Laser DotLaser Dot

Front SightFront Sight

Rear SightRear Sight

FIGURE A11