Installation Guide

CROWN MOULDING INSTALLATION INSTRUCTIONS

1. Measure wall where crown moulding will be installed.

2. Cut crown moulding to installation length.

3. Install hangers: for crown moulding up to 12’ use 2 hangers; for over 12’ use 3

hangers for proper support of moulding.

a) Hangers should be positioned on the wall for equal support of the

moulding; for example, if using 2 hangers place them 1/3 of the way from

each end.

b) Install a 1 ½” roofing nail, 1” from the ceiling, leaving nail head ¼” out

from the wall.

c) Place a hanger on each nail. To lower bracket, loosen knob; re-tighten

knob after lowering bracket.

4. Place moulding on hangers.

5. Loosen hanger knob and raise the moulding to ceiling by pushing the support

bracket upwards. Re-tighten hanger knob.

6. Check moulding fit before installation.

7. Beginning at one end, attach moulding using finishing nails (or power nailer).

8. When you are within two feet of a hanger, loosen the knob and remove the

hanger. Roofing nail (Step 3b) is left behind the molding.

PAGE 1
CROWN MOULDING INSTALLATION INSTRUCTIONS 1. Measure wall where crown moulding will be installed. 2. Cut crown moulding to installation length. 3. Install hangers: for crown moulding up to 12’ use 2 hangers; for over 12’ use 3 hangers for proper support of moulding. a) Hangers should be positioned on the wall for equal support of the moulding; for example, if using 2 hangers place them 1/3 of the way from each end. b) Install a 1 ½” roofing nail, 1” from the ceiling, leaving nail head ¼” out from the wall.