Users Manual Part 1

10
CAUTION: Do not use excessive force when
separating the communication module cap from
the base. The antenna cable must remain attached
to both the cap and base. Disconnecting the
antenna cable may result in damage to the antenna
and/or communication module electronics.
Communication
Module
Cap
Communication Module Base
Antenna Cable
Battery Plug
Battery Receptacle
WARNING: Ensure that the seals around the module
cap perimeter and screw holes are not lost or
damaged as the module is opened or closed. These
O-ring seals are necessary for water ingress and ESD
protection.
10. Place the cap of the communication module onto
the base, taking care to tuck the antenna cable
completely inside the communication module.
11. Insert and tighten the two star screws under the
communication module cap using the 10 IP star-
shaped drive bit until they are fully seated then
another 1/8 turn (45 degrees) approximately. Do
not over tighten.