Users Manual Part 1

12
To charge the rechargeable battery:
1. Plug the power cord for the CADD®-Solis AC
adapter into an AC outlet and the other end into
the AC adapter.
2. Plug the AC adapter connector into the AC power
jack (labeled “7V”) on the CADD®-Solis pump.
When properly connected, the blue light next to
the connector on the pump lights up.
WARNING: Do not connect any AC adapters directly
to the CADD®-Solis Communication Module
rechargeable battery. Directly connecting any AC
adapter could be hazardous and can damage the
battery, communication module, and the pump.
CAUTION: Failure to push the AC adapter output
connector all the way inward to the pump may
result in an intermittent connection and the
connector may dislodge, causing a loss of power
and will no longer charge the rechargeable battery.
3. When the pump is
powered on, the
pump status bar
briey shows “AC
Adapter Connected.”
4. When the pump is
powered on, the
pump
status bar shows that the pump is connected to
AC power. A small plug indicator is shown to the
right of the battery icon.
5. When the pump is powered on, you can assess
the estimated battery power level from the status
bar on the pump display. For more information,
refer to the pump Operator's Manual.
When the battery
is fully charged,
you may choose
to disconnect the
AC adapter plug.
The “AC adapter
disconnected”
message is briey
displayed after
disconnecting the plug.
Conguring Wireless Settings Using the
CADD®-Solis Network Setup Utility Software
All wireless settings for the pump and CADD®-Solis
Communication Module are congured using the
CADD®-Solis Network Setup Utility software
(available separately) via a USB connection from a PC
to the CADD®-Solis pump.
The CADD®-Solis Network Setup Utility software
lets you select and enter all wireless settings for
conguration to your wireless network access points,
and your PharmGuard® Server. Those settings can
be saved to the CADD®-Solis pump. Therefore, if a
CADD®-Solis Communication Module is replaced
for the pump, the new communication module will
automatically use the pump's pre-congured wireless
settings.