Users Manual Part 1

6
CAUTIONS
• Do not use excessive force when separating
the CADD®-Solis Communication Module cap
from the base. The antenna cable must remain
attached to both the cap and base.
• Disconnecting the antenna cable may result in
damage to the antenna and/or communication
module electronics.
• Failure to fully charge the CADD®-Solis
Communication Module rechargeable battery
prior to initial use and during prolonged storage
may cause deep battery discharge, leading to
premature battery replacement.
• The USB port on the CADD®-Solis Infusion Pump is
intended for communication to the PharmGuard®
Medication Safety Software, SureLink® Remote
Support Software, and the CADD® Solis Network
Setup Utility software only. Do not connect
unsupported accessories to the USB port (e.g.,
charging other devices, attaching a wireless
dongle) as this could damage the pump.
• If the CADD®-Solis Communication Module
is stored outside of the environmental
operating conditions and within the specied
environmental storage conditions, allow the
communication module to warm or cool to
operating temperature for at least one hour prior
to use to avoid damaging the electronic circuitry.
About The CADD®-Solis Communication
Module, Model 2131
The CADD®-Solis Network Communication System
(NCS) consists of a CADD®-Solis Ambulatory Infusion
Pump, Model 2110 (software version 4.2 or greater),
with a CADD®-Solis Communication Module installed
and congured for your wireless network and
PharmGuard® Server. When installed and appropriately
congured, the communication module lets the
pump wirelessly send pump history to a PharmGuard®
Server, and to receive pump rmware and library
updates.
The model 2131 is an upgraded communication
module from the 2130. The radio is more robust,
including better security and encryption and
incorporating 20 MHz channel ‘n’ band support.
The CADD®-Solis
Communication Module
includes the wireless radio and
a rechargeable battery inside
the module. The battery powers
the communication module,
and provides power for the
CADD®-Solis pump when AC
power is not readily available.
The rechargeable battery is
charged whenever the pump is
plugged into AC power via the
CADD®
-Solis AC Adapter—even
if the pump is turned o.
The CADD®-Solis AC adapter
and power cord (available
separately) is used to connect
to the pump to recharge the
battery when the communication
module is installed in the CADD®-
Solis pump.