Users Manual Part 1

7. Verify the three new pogo pin insulators are fully seated around the pins.

NOTE: The three new pogo pin insulators are also compatible with AA batteries and the CADD®-Solis

Rechargeable Battery Pack. Discard the original pogo pin insulators as they are no longer needed.

8. The rechargeable battery inside the communication module is not connected and must be internally

connected. To access the battery to connect it, use a 10 IP star-shaped drive bit to remove the two screws

under the cap of the communication module.

WARNING: To avoid potential injury and damage, do not remove the cap of the communication module while

it is installed and connected to the pump or allow the electronic contacts of a Communication Module to

simultaneously touch a piece of metal (a coin or paper clip, for in stance).

9. Gently remove the cap from the base of the communication module, taking care to keep the antenna

cable from pulling loose from either the cap or the base, and then attach the battery plug to the battery

receptacle on the communication module printed circuit board.