Installation Manual

WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Street Light Bar (Part # 130010)
04-08 Ford F150
Parts Included QTY Parts Included QTY
Light Bar 1 15/16” Nuts 2
½” x 5/8” 2 2” Washers 2
Step 1: Locate the two plastic inserts in each corner of the bumper opening, remove and discard. This will
expose a factory mounting location behind the bumper on both sides. NOTE: The mounting locations will
be a round or oval hole through a metal plate on both sides. (Fig A)
(Fig A)
Step 2: Match up the light bar brackets to the factory mounting holes through the bumper. Next, start a 1
1/2” x 5/8 bolt, 15/16 nut, and 2” washer and hand tighten. Repeat on other side. Installation is now complete.
CARE AND MAINTENANCE
To protect your investment it is recommended to regularly wash and wax this part. Do not use any type of cleaners that contain abrasives that may damage the finish
of your part.
LIMITED WARRANTY
Smittybilt (The Company) warrants to the original purchaser of this product that should the product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 5 years
from the original date of purchase, such defect(s) will be repaired or replaced (At the Company’s option) without charge for parts or labor.
To obtain repair or replacement within the terms of the warranty, the product is to be delivered with proof of warranty coverage ( e.g. dated bill of sale, receipt), specification of defect, freight pre-paid with Returns Good
Authorization Number from Smittybilt to place of purchase. Items returned to Smittybilt without a Returns Authorization Number will be refused and returned to sender at the sender’s expense. This warranty does not
apply to any product or part thereof which, in the opinion of the Company, has suffered or been damaged through altercation, improper installation, mishandling, misuse, neglect accident or acts of nature. THE EXTENT
OF THE COMPANY’S LIABILITY UNDER THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT PROVIDED ABOVE AND, IN NO EVENT, SHALL THE COMPANY’S
LIABILITY EXCEED THE PURCHASE PRICE PAID BY THE PURCHASER FOR THIS PRODUCT.
This warranty is in lieu of all expressed warranties and liabilities. ANY IMPLIED WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY SHALL BE LIMITED TO THE DURATION
OF THIS WRITTEN WARRANTY. ANY ACTION FOR BREACH OF ANY WARRANTY HEREUNDER INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY MUST BE BROUGHTH WITHIN
A PERIOD OF 90 DAYS FROM DATE OF ORIGINAL PURCHASE.IN NO CASE SHALL THE COMPANY BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES FOR BREACH OF THIS
OR ANY OTHER WARRANTY, EXPRESSED OR IMPLIED,WHATSOEVER. No person or representative is authorized to assume for the company any liability other than expressed herein in connection with the sale
of this product. Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damage, therefore above limitations may not apply to you. This
warranty gives the purchaser specific legal rights. The purchaser may have additional rights, which vary from state to state.
NOTE:
Please read instructions entirely before installing this product
Products licensed to N-fab Inc. by Fichter Designs are protected by US patent law and International Copy Right law. US Patent # 6588783, # 6874801, #
7416202. Other patents and continuances pending. N-fab products configuration also protected by International Trade Dress Law. All Design and Patent
infringements will be prosecuted to the full extent of the law.
Remove
plastic/mesh
inserts at the
corners of the
lower bumper
insert area.
The light bar
attaches to the
OEM metal
plates behind the
inserts into the
existing holes.