Manualshelf

Installation Manual

ManualsBrandsSmittybilt ManualsAutomotiveSmittybilt 2722 Universal Trail Jack - 54"
123
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
TRAIL JACK- 54”
(PART # 2722)
Danger
To Avoid Serious Handle Impact Injury, Crushing Or Death please read and understand the following.
• This Jack will not stabilize the load. You must chock and block (stabilize) the load securely to prevent it from falling.
• Do not use Jack to support a load. Never get under a raised load.
• Always clip the handle against the steel standard (bar) before moving the reversing latch.
• If your hands slip off the handle, or if the handle is horizontal when the reversing latch is moved down, it may move up very
quickly. If your head is in the handle’s travel path, it could strike you.
Warning
• Do not use this Jack on curved or tubular vehicle bumpers. The vehicle could slip off the Jack and fall, causing serious injury or
death. Use the Bumper Lift to lift most vehicles with curved or slotted bumpers.
• Do not raise inflated tire more than 2” (5cm) above the ground. Never attempt to lift more than one wheel at a time.
• If the shear bolt breaks as it will at 7,000 lbs. (3,175 kg) use a Jack with a larger load capacity to lower the load safely to the
ground.
• Do not replace the shear bolt while the Jack is under load.
NOTE: Carefully read entire instructions thoroughly
before using this product.
Trail Jack is not self lubricating and will not operate
safely without proper lubrication. Lubricate all working
parts and edges of steel bar regularly.
MAXIMUM RATED LOAD IS 4,660 LBS. (2,116 KG) UP TO 54”
(137CM) TESTED TO 4400 LBS. (2,000 KG) UPPER 12” OF 60” JACK
IS RATED TO 2,660 LBS. (1,209 KG) ONLY, TESTED TO 4,000 LBS.
(1,818 KG).
TOP CLAMP LIMITED TO 750 LBS. (340KG) CLAMPING AND 5,000
LBS. (2,273 KG) WINCHING. BUMPER LIFT ACCESSORY LIMITED
TO 3,000 LBS (1,360KG)
MAXIMUM RATED LOAD FOR EQUIPMENT- TRAIL JACK SIDE
LIFT IS 2,000 LBS (910KG).
HANDLE FORCE REQUIRED TO RAISE 4,660 LBS (2,116 KG) IS
177 LBS. (80KG) AT 34” (86CM) ON THE HANDLE.

Summary of content (3 pages)