User Manual

WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Low Profile Roller Fairlead
Part # 2810
Parts Included Qty
Parts Included Qty
Roller Fairlead 1 M12 nut 2
M12 x 40mm Hex Bolt 2 M12 Flat Washer 2
Step 1: Remove current fairlead from bumper. (If equipped)
Step 2: Hold new roller fairlead on bumper centering it over the winch rope slot. (Fig A)
Step 3: Once fairlead is centered mark the holes. (Fig B)
Step 4: Set the roller fairlead to the side and drill out the previously marked holes. (Fig C)
(Fig A) (Fig B) (Fig C) (Fig D)
Step 5: Hold fairlead back on bumper and insert included hardware. (Fig D)
Step 6: Make sure fairlead is centered and straight and then secure hardware. Installation is now complete
Limited Warranties
Smittybilt’s products are covered under the following limited warranties only. Note that the duration of the limited warranty differs according to the material and finish of the
product purchased. Subject to the duration and conditions of the limited warranty stated below, Smittybilt warrants to the original retail purchaser that its products are free
from defects in material and workmanship. All other warranties and representations express or implied, are hereby disclaimed, including fitness for merchantability and
buyer’s intended use or purpose. All parts are sold “AS IS” except for the limited warranties granted herein. Buyer assumes all risks as to the selection, suitability and
performance of all goods and products selected. This limited warranty does not cover damage or impairment in any part due to misuse, improper installation, accident or
contact with on-road or off-road hazards, product modification, improper or inadequate cleaning and/or maintenance. Smittybilt is not responsible for items damaged during
shipping. This warranty is not transferable from the original buyer. For the original Buyer to be eligible for the limited warranty coverage, the Buyer must provide proof of
purchase. Smittybilt strongly recommends returning the warranty registration card.
Customer’s remedy hereunder shall be limited only to repair or replacement (at Smittybilt’s option) of any defective part(s) returned to Smittybilt at customer’s expense.
The determination of whether or not a returned part is defective or subject to coverage under the limited warranties stated herein shall be made at Smittybilt’s sole
discretion. 1. Limited One (1) Year Limited Warranty Low Profile Roller Fairleads
This Smittybilt product carry’s the foregoing limited repair or replacement warranty for a period of (1) one-year against workmanship and defects in the material from
the date of purchase.
To assure product quality, Smittybilt reserves the right to change product design, material, specification and finishes without prior notice to customers. This limited warranty
gives you specific legal rights and you may also have other rights, which may vary from state to state. Some states do not allow limitations on how long an implied
warranty lasts, so the above limitations may not apply as to you. Also, some states do not allow the exclusion or limitation of incidental or consequential damages, so the
above limitations or exclusions may not apply to you. Smittybilt reserves the right to discontinue product lines and substitute products, or provide other remedies than
those listed in this limited warranty for those discontinued products.
Note:
Read instructions entirely before installing this product. Always use caution when
drilling and wear eye protection.