Installation Manual

WWW.SMITTYBILT.COM

For Technical Support/Warranty Information please call 310-762-9944

Smittybilt, 400 West Artesia Blvd, Compton, CA 90220

Installation Instructions

License Plate Bracket

Universal for 3” Tubes

Part # 4430

Parts Included Qty

License Plate Bracket 1

5mm Nut 5

Rubber Sleeve 1

5mm Flat Washer 5

6x20mm Phillips Screw 4

5mm Lock Washer 5

6x40mm Hex Head Bolt 1

Step 1: Install rubber sleeve on bracket, by sliding it over the plate. (Fig A)

Step 2: Determine the optimal location for the bracket. Carefully spread the “C” bracket apart

in order to get it over/around the tube. (Fig B)

(Fig A) (Fig B)

Step 3: Secure the bracket on the bumper using the included 6x40mm bolt and hardware. (Fig C)

Step 4: Installation is now complete. (Fig D) Install your license plate using the included 6x20mm

hardware.

Please read instructions entirely before installing this product.

PAGE 1
Installation Instructions License Plate Bracket Universal for 3” Tubes Part # 4430 WWW.SMITTYBILT.COM Please read instructions entirely before installing this product. Parts Included License Plate Bracket Rubber Sleeve 6x20mm Phillips Screw 6x40mm Hex Head Bolt Qty 1 1 4 1 Parts Included 5mm Nut 5mm Flat Washer 5mm Lock Washer Qty 5 5 5 Step 1: Install rubber sleeve on bracket, by sliding it over the plate. (Fig A) Step 2: Determine the optimal location for the bracket.
PAGE 2
Installation Instructions License Plate Bracket Universal for 3” Tubes Part # 4430 WWW.SMITTYBILT.COM (Fig C) (Fig D) Compliment your new Tube Bumpers with other quality Smittybilt products Soft Goods Seat Covers Sure -Steps Limited Warranties Smittybilt’s products are covered under the following limited warranties only. Note that the duration of the limited warranty differs according to the material and finish of the product purchased.