Installation Manual

TOOLS REQUIRED
- Phillips Screwdriver
- 4mm Wrench
WWW.SMITTYBILT.COM
INCLUDED COMPONENTS
1 – Grille (1 pieces)
6 – 90°L Brackets
8 – 70°L Brackets A
2 – 70°L Brackets B
16 – M4*16mm Phillips Screws
32 – M4 Flange Nuts
INSTALLATION INSTRUCTIONS
1. Inspect product and check components with items listed above.
2. Pop Hood, remove plastic shroud at the top and set fasteners aside.
3. Optional: Using factory instructions, remove the entire front grille shell (as pictured in all Figures).
4. Attach the six 90°
°°
°L Brackets to the screws on the bottom of the grille, secure them with flange nuts.
5. Attach the eight 70°
°°
°L Brackets A to the screws on the top of the grille, secure them with flange nuts.
6. Attach the two 70°
°°
°L Brackets B to other screws of the grille, secure them with flange nuts
7. Position the Grille onto grille shell cavity (Figure 2).
8. Mark locations for drilling on the shell through the holes of L Brackets. Then drill holes on those locations.
9. Attach the Grille to the shell by inserting the screws through the tabs of L Brackets and holes on the shell; secure
them with Flange Nuts provided (Figure 3).
10. Reinstall the plastic shroud with the fasteners removed in Step 2.
Figure 1 – Included Hardware
Figure 3
–
Rear view of vehicle’s shell; Grills attached with Metal Brackets and Flange Nuts
Figure 2
–
Front View of positioning Grille
Installation Instructions
M1 Wire Mesh Grille
(Part #615801)
09-on Dodge Ram 1500
NOTE: Carefully read entire instructions thoroughly before attempting to install this part.
It is recommended to have this part installed by an experienced shop/mechanic.