Manualshelf

Installation Manual

ManualsBrandsSmittybilt ManualsAutomotiveSmittybilt 615821 M1 Stainless Steel Wire Mesh Grille for Chevy Silverado 1500
12
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
WWW.SMITTYBILT.COM
INCLUDED COMPONENTS
1 – Grille (2 pieces)
28 – 90°L Brackets
28 – M4*20mm Phillips Screws
56 – M4 Flange Nuts
INSTALLATION INSTRUCTIONS
1.
Inspect product and check components with items listed above.
2.
Pop Hood, remove plastic shroud at the top and set fasteners aside.
3. Optional:
Using factory instructions, remove the entire front grille shell (as pictured in all Figures).
4. Attach 90°L Brackets
to the screws on the
5.
Position the Grille onto grille shell cavity (Figure 2).
6.
Mark locations for drilling on the shell thought the other hole on the “L” brackets, then remove the brackets and
drill holes on the these locations.
7. Attach the Grille to the shell by
inserting
and then
secure them with Flange Nuts provided (Figure 3).
8.
Reinstall the plastic shroud with the fasteners removed in Step 2.
Figure 3 –
Rear view of vehicle’s shell; Grills attached with Metal Brackets and Flange Nuts
Figure 2
NOTE: Carefully read entire
It is recommended to have this part installed by an experienced shop/mechanic.
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
TOOLS REQUIRED
-
Phillips Screwdriver
- 4mm
Wrench
Inspect product and check components with items listed above.
Pop Hood, remove plastic shroud at the top and set fasteners aside.
Using factory instructions, remove the entire front grille shell (as pictured in all Figures).
to the screws on the
grille, secure them with flange nuts.
Position the Grille onto grille shell cavity (Figure 2).
Mark locations for drilling on the shell thought the other hole on the “L” brackets, then remove the brackets and
inserting
the screws through the holes of
L Brackets and
secure them with Flange Nuts provided (Figure 3).
Reinstall the plastic shroud with the fasteners removed in Step 2.
Figure 1 – Included Hardware
Rear view of vehicle’s shell; Grills attached with Metal Brackets and Flange Nuts
Figure 2
–
Front View of positioning Grille
Installation Instructions
M1 Wire Mesh Grille
(Part #615821)
07-
on Chevy Silverado 1500
instructions thoroughly before
attempting to install this part.
It is recommended to have this part installed by an experienced shop/mechanic.
TOOLS REQUIRED
Phillips Screwdriver
Wrench
Using factory instructions, remove the entire front grille shell (as pictured in all Figures).
Mark locations for drilling on the shell thought the other hole on the “L” brackets, then remove the brackets and
L Brackets and
the holes on the shell,
Rear view of vehicle’s shell; Grills attached with Metal Brackets and Flange Nuts
Installation Instructions
M1 Wire Mesh Grille
on Chevy Silverado 1500
attempting to install this part.
It is recommended to have this part installed by an experienced shop/mechanic.

Summary of content (2 pages)