Installation Manual

For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 W. Artesia Blvd, Compton, CA 90220
Installation Instructions
SRC OFF ROAD ROOF RACK
87-95 Wrangler,97-06 Wrangler,04-06 Unlimited
Part #’s 76711,76713,76715)
5. Remove the factory rear bumper and bolts. (If re-
installing factory bumper proceed to step 16 before
moving on.)
6. Insert the bolts with flat washers through the rear
bumper. Do not install the nuts at this time. Just use the
bolts to hold the bumper in place.
7. Insert the front overhead bar (straight bar) into the front
upright. Insert a 1/4/20 x 2.5” Allen Head Bolt with a
flat washer, through the bar and the upright. Then place
another flat washer, a lock washer and the locking nut on
the bar. DO NOT TIGHTEN. Have an assistant hold
the bar in place for steps 8&9 (important or you vehicle
may get scratched) (Figure 4)
8. Repeat step 5 for the rear overhead bar (curved bar).
Do not tighten. (Figure 5)
9. Insert the rear upright into the rear overhead bar. Then
position the rear upright on the backside of the bumper
bolts. Install a flat washer and locking nut on the rear
upright bolts. DO NOT TIGHTEN. Install the 1/4/20 x
2.5” Allen Head Bolt with a flat washer, through the
upright as in steps 7 & 8. Do not tighten (Figure 6)
10. (Option – Body Lift Spacers) – If your vehicle has a
body lift use the supplied spacers to separate the lower
upright from the rear overhead bar. 1”, 2” and 3”
spacers are provided.
11. Repeat steps 7-9 for the opposite side.
Figure 4
Figure 5
Figure 6 – Uprights installed
but not tightened – Important,
do not tighten until the cross
bars are installed.