Installation Manual

ManualsBrandsSmittybilt ManualsAutomotiveSmittybilt 76870 XRC Textured Black Rock Slider Rocker Guards

WWW.SMITTYBILT.COM

For Technical Support/Warranty Information please call 310-762-9944

Smittybilt, 400 West Artesia Blvd, Compton, CA 90220

Installation Instructions

XRC Rocker Guards

Part # 76872, 76871, 76861, 76862

Parts Included Qty

Driver Side Rocker Guard 1

Passenger Side Rocker Guard 1

3/8” Counter-sunk Bolt 10

3/8”Flat Washer 10

3/8”Lock Nut 10

Step 1: Take off and remove any existing flares or rocker guards that you may have on your vehicle.

(Fig A) Make sure to clean the side of the vehicle before installing the guards.

Step 2: Loosen the lower bolts on each of the front and rear flares. (Fig A)

(Fig A) (Fig B)

Step 3: Remove all of the body mount bolts on the passenger side (or which ever side you begin with)

including the front one. Note: Make sure vehicle is on a level surface.

NOTE: Carefully read entire instructions thoroughly before attempting to install this part.

Remove any existing plastic

flares/steps or rocker guards

on the side of your vehicle.

Loosen the bottom bolts of both the

front and rear fender flares.

Summary of content (5 pages)

PAGE 1
Installation Instructions XRC Rocker Guards Part # 76872, 76871, 76861, 76862 WWW.SMITTYBILT.COM NOTE: Carefully read entire instructions thoroughly before attempting to install this part. Parts Included Driver Side Rocker Guard Passenger Side Rocker Guard 3/8” Counter-sunk Bolt 3/8”Flat Washer 3/8”Lock Nut Qty 1 1 10 10 10 Step 1: Take off and remove any existing flares or rocker guards that you may have on your vehicle. (Fig A) Make sure to clean the side of the vehicle before installing the guards.
PAGE 2
Installation Instructions XRC Rocker Guards Part # 76872, 76871, 76861, 76862 WWW.SMITTYBILT.COM Step 4: Raise the body of the vehicle slightly using a floor jack. Be sure to lift near a body support to prevent any damage to your vehicle. (Fig B) Step 5: Hold the guard up close to vehicle to identify which body mounts line up with the cut out slots on the bottom of your rocker guard. Set guard to the side and carefully remove the body mounts and sleeves that line up with the slots.
PAGE 3
Installation Instructions XRC Rocker Guards Part # 76872, 76871, 76861, 76862 WWW.SMITTYBILT.COM Note: On CJ’s and late model TJ’s an access hole will be needed to install the nut on the rear bolt on the corner guard. This can be done by using a 1” hole saw on the inside of the body near the lower seat belt mount. On CJ’s and late TJ’s you will need to drill an access hole in order to attach nut to bolt. (Fig F) (Fig G) (Fig H) Step 12: Position the guard back on the vehicle.
PAGE 4
Installation Instructions XRC Rocker Guards Part # 76872, 76871, 76861, 76862 WWW.SMITTYBILT.
PAGE 5
Installation Instructions XRC Rocker Guards Part # 76872, 76871, 76861, 76862 WWW.SMITTYBILT.