Installation Manual

WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Body Cladding
07-11 JK Unlimited (4-Dr)
Part # 76887
Step 2: Moving forward, locate and test fit 93-7472 Mark edges and holes. Inspect that the panels will not
overlap. View figure A for lay out
Step 3: Moving forward again, locate 93-7470 and 93-7471. If your vehicle has Smittybilt fenders (76880) use 93-
7470. If it has stock fenders use 93-7471. Check fit and mark the appropriate part.
Step 4: Locate 93-7474 and 93-7475. If your vehicle is fitted with Smittybilt corner guards (76882) use 93-7475. If
the vehicle is stock, use 93-7474. Check fit the appropriate part. mark the holes and edges and remove. See figure B
Step 5: Now that you have check fit all the panels. Make sure none of the panels overlap. Center punch your
marked holes and drill to .531 or 17/32. See figure B
Figure B
(TIP) Use a step drill or ''unibit" to speed up the drilling process.
Step 6: Deburr all holes. Make sure the surface is flat.
Step 7: Using nutcerts from hardware pack (90-6778) install nutcerts into previously drilled holes. See figure C
NOTE: If you do not have a professional nutcert installation tool, use the 2 1/2” X
3/8” socket head bolt, 3/8” nut and washer. Install the nutcert into the 1/2” hole on the
vehicle. Thread the nut up as far on the 3/8” bolt as it will go and then follow that with the
washer. Thread the bolt, nut, washer, nutcert tool (96-5951) and star washer assembly
into the nutcert. (Fig. D) While holding the 3/8” bolt with an Allen wrench, tighten the
nut and washer down against the nutcert. Use the nutcert tool and star washer to keep the
nutcert body from spinning while tightening the 3/8” bolt. Once the nutcert is properly
installed into the vehicle remove the 3/8” bolt, nut, washer, nutcert tool (96-5951) and star
washer . See figure C