Owners manual

Installation Instructions

Door Skins Pair (#896xx,897xx)

1987-2006 Jeep Wranglers

For Technical Support/Warranty Information please call 310-762-9944

Smittybilt, 400 West Artesia Blvd, Compton, CA 90220

Included Components:

1-Door Skin Driver Side

1-Door Skin Passenger Side

INSTALLATION INSTRUCTIONS:

THE TEMPERATURE SHOULD BE ABOVE 70 DEGREES FARENHEIT.

efore you begin, the temperature of the Door Skin should be above70 degrees Fahrenheit. We

suggest laying the door skin in the sunlight for 1 hour before installation. If you can’t install the Door

Skin in a 70 F (or warmer) environment, carefully use a hairdryer to warm the material. Installations

performed below 70 F can be difficult. They are designed to be a tight fit to eliminate any flapping and

A better fit.

NOTE: Instructions are configured for the driver side.

1. After removing skins from packaging, leave the Door Skins out in the sunlight for at least 1 hour.

2. Insert the frame into the upper rear corner of the door skin and then insert the Frame into the

upper front corner of the Door Skin. Press down the Velcro to secure the frame bar.

Driver Side Door Frame

(not included)

Driver Side Door Skin

Door Skin

Velcro Open

PAGE 1
Installation Instructions Door Skins Pair (#896xx,897xx) 1987-2006 Jeep Wranglers Included Components: INSTALLATION INSTRUCTIONS: 1-Door Skin Driver Side 1-Door Skin Passenger Side THE TEMPERATURE SHOULD BE ABOVE 70 DEGREES FARENHEIT. Before you begin, the temperature of the Door Skin should be above70 degrees Fahrenheit. We suggest laying the door skin in the sunlight for 1 hour before installation.
PAGE 2
Installation Instructions Door Skins Pair (#896xx,897xx) 1987-2006 Jeep Wranglers 3. Insert the lower front corner of the Frame into the Door Skin (tight fit). 4. Wrap the Velcro around the Frame that runs the length of the bottom and secure. 5. Make sure the three legs of the Frame are seated in the 3 cut-away parts of the Door Skin. Close the 2 large and 1 small flaps on the bottom of the Door Skin. Now is Door Skin is assembled. 6.
PAGE 3
Installation Instructions Door Skins Pair (#896xx,897xx) 1987-2006 Jeep Wranglers LIMITED WARRANTY Smittybilt (The Company) warrants to the original purchaser of this product that should the product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within the warranty period of 1 year from the date of purchase, such defect(s) will be repaired or replaced (At the Company’s option) without charge for parts or labor.