Installation Manual

ManualsBrandsSmittybilt ManualsAutomotiveSmittybilt 93635 Extended Top Black Diamond for 1997 to 2006 TJ Wrangler and Rubicon

Installation Instructions

Extended Top (Part #,936xx)

1997-2006 Jeep Wranglers

For Technical Support/Warranty Information please call 310-762-9944

Smittybilt, 1600 Walnut Parkway, Compton, CA 90220

Installation re

uires an aftermarket Windshield Channel

(

Smitt

bilt Part # 90104

)

Included Components:

1-Brief

2-J-Clips

INSTALLATION INSTRUCTIONS:

Before you begin, the temperature of the Brief should be above 70 degrees Fahrenheit. We suggest

laying the Brief in the sunlight for 1 hour before installation.

Figure 1

1. Locate the rubber blade on front edge (Figure 1).

2. Place the Brief on top of Jeep. Insert rubber blade into Windshield Channel, working from one side

of vehicle to the other (Figures 2 & 3).

Figure 2

Figure 3

Summary of content (6 pages)

PAGE 1
Installation Instructions Extended Top (Part #,936xx) 1997-2006 Jeep Wranglers Installation requires an aftermarket Windshield Channel (Smittybilt Part # 90104) Included Components: INSTALLATION INSTRUCTIONS: 1-Brief 2-J-Clips Before you begin, the temperature of the Brief should be above 70 degrees Fahrenheit. We suggest laying the Brief in the sunlight for 1 hour before installation. 1. Locate the rubber blade on front edge (Figure 1). 2. Place the Brief on top of Jeep.
PAGE 2
Installation Instructions Extended Top (Part #,936xx) 1997-2006 Jeep Wranglers 3. Locate 2 Velcro straps in each front corner of the Brief (Figure 4) • Wrap Strap A over the top of the bar towards the inside of the vehicle (Figure 5). The Velcro of Strap A should be facing outward from the roll bar. • Strap B wraps around the outside of the roll bar. • Attach Strap B to Strap A on the underside of the roll bar (Figure 6). • Do both driver and passenger sides of the vehicle.
PAGE 3
Installation Instructions Extended Top (Part #,936xx) 1997-2006 Jeep Wranglers 5. Locate the center strap along the central roll bar. Run the center strap around the rear and under the central roll bar forward to the Footman Loop near the top center of the windshield. Run strap through Footman Loop and feed strap through its buckle securely (Figure 8). Figure 8 NOTE: The rear straps can be fastened in two different methods: Option 1 shows how to attach the Brief to your vehicle using J-Clips.
PAGE 4
Installation Instructions Extended Top (Part #,936xx) 1997-2006 Jeep Wranglers 7. Wrap the straps around the roll bar or seat belt shoulder harness. Feed the loose end through the buckle and pull tight (Figure 11). Be sure not to interfere with the seat belts safety and operation. Place the strap under the seat belt. Never install over the seat belt strap. 8. Locate the two side straps near the central roll bar.
PAGE 5
Installation Instructions Extended Top (Part #,936xx) 1997-2006 Jeep Wranglers Option 2 (without J-Clip) 10. Wrap the straps around the seat belt shoulder harness and roll bar. Feed the loose end through the buckle on the other end and pull tight (Figure 13). Be sure not to interfere with the seat belts safety and operation. Place the strap under the seat belt. Never install over the seat belt strap. Figure 13 11. Locate two straps in the middle of each side of the Brief.
PAGE 6
Installation Instructions Extended Top (Part #,936xx) 1997-2006 Jeep Wranglers LIMITED WARRANTY Smittybilt (The Company) warrants to the original purchaser of this product that should the product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within the warranty period of 1 year from the date of purchase, such defect(s) will be repaired or replaced (At the Company’s option) without charge for parts or labor.