Installation Instructions Sure Step (Part # DN280-S4B/ DN280-S4S) 2010 Dodge Ram 2500/3500 Mega Cab For Technical Support/Warranty Information please call 310-762-9944 Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
PARTS LIST: Qty 1 1 1 1 1 1 1 1 2 1 1 2 4 4 4 Description Driver/Left Sidebar Passenger/Right Sidebar Driver/Left Front Mounting Bracket Passenger/Right Front Mounting Bracket Driver/Left Front Support Bracket Passenger/Right Front Support Bracket Driver/Left Center Mounting Bracket Passenger/Right Center Mounting Bracket Rear Mounting Brackets Driver/Left Rear Support Mounting Bracket Passenger/Right Support Mounting Bracket Rear Support Strap 1/2” x 2” Hex Bolts 1/2” Lock Washers 1/2” X 1-1/2” OD x 1/8"
threaded nut lines up with the remaining hole in the Mounting Bracket and body. Thread (1) 10mm x 35mm Hex Bolt, (1) 10mm Flat Washer and (1) 10mm Lock Washer into the threaded nut. Do not tighten hardware at this time. 5. Remove the driver side front factory body bolt and washer. Select the driver side Front Support Bracket. Insert the factory body bolt and washer through the slot in the Support Bracket and up into its original position, (Figure 3).
DRIVER SIDE INSTALLATION PICTURED Fig 1A Fig 1B Rotate Bolt and Nut plate to line up Nut with this hole in body panel Fig 2 Front Front Remove the factory body mount bolt and washer, line up the slot in the driver side Support Bracket and reinstall the factory bolt and washer. Front Fig 3 Front (Fig 4) Rotate Bolt and Nut plate to line up Nut with this hole in body panel. Center Mounting Bracket location pictured.
(1) Bolt Plate w/12mm retainer (1) 12mm Lock Washer (1) 12mm Flat Washer (1) 12mm Hex Nut DRIVER SIDE INSTALLATION PICTURED Push rear Mounting Bracket up against the body as you tighten hardware Rear (Fig 6) Rear mounting position pictured Fig 7 (2) 10mm x 35mm Hex Bolts (2) 10mm Lock Washer (4) 10mm x 20mm Flat Washer (2) 10mm Hex Nut Fig 9 Fig 8 1/2" x 2" Hex Bolt 1/2" Flat Washer 1/2" Lock Washer 8mm x 25mm Hex Bolt 8mm Flat Washer 8mm Lock Washer Fig10 Complete Installation Front Page 4 of
Cleaning and Maintenance To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer over the finish. For stainless steel: aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap, window or glass cleaner may be used also. For gloss black finishes. Mild soap, window and glass cleaner may be used. Do not use any type of polish or wax that contains abrasive that could damage the finish.
