User Manual

Page 3
Step 1
Install Batteries (Supplied)
• Remove the battery cover from the bottom of the iCalc.
• Insert the 2 AAA batteries (supplied) into the battery slots.
Make sure the positive (+) and negative (-) ends of the batteries
match the polarity markings inside the battery compartment.
• Snap the battery cover back into position.
• Turn on the power by sliding the ON/OFF switch located
at the bottom of the iCalc to the ON position.
Page 16
Declaration of Conformity
Manufacturer:
SMK-Link Electronics Corporation
3601-B Calle Tecate
Camarillo, CA 93012
Hereby, SMK-Link declares that the VP4585 is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC.
EMC/EMI/Safety Standards
EN 300 440-2 V1.1.1 (2001-09)
EN 301 489-1 V1.4.1 (2002-08)
EN 301 489-3 V1.4.1 (2002-08)
EN 60825-1 (1994, A11:1996, A2:2001)