User's Manual

SAT Auto-Tune

Setting SAT Auto-Tune Channel

SAT Auto-Tune programs into the remote control

the correct TV channel used for viewing your paid

programming. If you are experiencing fuzzy, snowy,

blue, or black screens, it might be due to the TV

being set to the wrong channel. Using the SAT Auto-

Tune feature helps prevent these screen issues from

occurring on TVs connected to the receiver’s modulated

output (usually TV2). Use SAT Auto-Tune to program the

correct TV channel for satellite viewing into the remote

control. When SAT is pressed and released, the remote

sends that channel to the TV, ensuring that the TV is on

the correct channel for viewing your paid programming.

This feature is enabled by default; however, if you want

to use this feature, the channel must be programmed by

following the steps in Setting SAT Auto-Tune Channel.

Make sure the remote control

operates your TV.

Press and hold TV for three

seconds until all four Mode

buttons are lit.

Press STAR (*).

Enter the channel used for

viewing (two or three digits

in range of 002 to 125), for

example channel “10” or “010.”

Press POUND (#). The Mode

button ashes three times to

indicate programming was

successful.

Press SAT. The channel

changes.