User's Manual

Recovering Your Picture

Use the RECOVER button to get back to watching

satellite programming if you accidentally change

channels or inputs on your TV, DVD, and/or VCR.

To use this feature, you must set up Auto-Tune for

your TV (see page 16) and for your DVD/VCR (see

page 18).

Note: RECOVER only works if the remote control

has been set up to control the TV and/or DVD/VCR,

if connected. If the RECOVER button is used, the TV

channel programmed for SAT Auto-Tune is also the

channel that is sent to the TV. RECOVER rst tries to

tune your TV to channel 3, then channel 4, and then other

video inputs with each press of the RECOVER button.

You may need to press the RECOVER button up to 30

times to recover your satellite TV video. If SAT Auto-Tune

is not set-up, RECOVER only tries channels 3 and 4.

Press and hold RECOVER

until all Mode buttons light up.

If you see the System Info

screen, proceed to step 4.

Otherwise, continue to step 3.

Press RECOVER again and

wait until the Mode lights

stop ashing. If you see the

System Info screen, go to

step 4. If not, repeat this step

until you see the screen.

Press SELECT to resume

watching TV.