User's Manual

28
Changing the Remote and
Receiver Address
If you notice that your receiver is changing
channels or opening menus, but you’re not
using the remote control, changing the address
should x the problem.
Press SYSTEM INFO on
the receiver’s front panel.
Write down the TV2
remote address shown on
the System Info screen.
Press and hold SAT on
your remote control for
about three seconds, until
all the Mode buttons light
up, and then release SAT.
Add one to the address
that you wrote down
in step 1, and use the
NUMBER PAD to enter
that number (between 1
and 28).
Press POUND (#).
Press RECORD.
Press several buttons on
the remote to make sure
it is working as expected.
1
2
3
4
5
6