Installation Guide

High Temp Limit Safety Switch Access/Replacement
Removal:
1. Make sure smoker is turned OFF and is unplugged from
electrical outlet
2. Remove all cooking grids and water pan from smoker
3. Remove rear handle - (2) screws - (Figure B1)
4. Remove rear vent - (6) screws - (Figure B2)
5. Remove rear panel - (17) screws - (Figure B1)
6. Remove (2) wires that are connected to tabs on High
Temp Limit Safety Switch - (Figure B3)
7. Remove (2) bolts and nuts from High Temp Limit Safety
Switch bracket - (Figure B3)
NOTE: Will need to secure bolts from inside smoker to remove.
Part Replacement Guide
Installation:
8. Position new High Temp Limit Safety Switch on back of
smoker where original switch was in place
9. Using (2) bolts and nuts, secure High Temp Limit Safety
Switch to inner back panel
10. Attach wires onto tabs of new High Temp Limit Safety Switch
11. Reattach rear panel - (17) screws
12. Reattach rear vent - (6) screws
13. Reattach rear handle - (2) screws
14. Place water pan and cooking grids back into smoker.
15. Plug smoker back into an electrical outlet
High Temp
Limit Safety
Switch
wire
connector
nut
nut
bolt
bolt
wire
connector
High Temp Limit
Safety Switch
Figure B3
Tools Needed: Phillips Screwdriver
Rear Handle
(2 screws)
Rear Panel
(17 screws)
Figure B1
Rear Vent
(6 screws)
Figure B2
21