User Manual

PROPRIETARY
The information contained in this document may be subject to change without notice.
The information contained in this document shall remain the sole exclusive property of s.m.s smart microwave sensors GmbH.
2012-06-07_UserManual_EKTSDG.doc I Page 11 of 15 I June 7, 2012 www.smartmicro.de
6 EKTSDG USB Serial Interface
EKTSDG can optionally be operated by a terminal program or by customer software.
The USB port is represented as serial interface by the driver software, that has been installed
according to section 3.3.
1. Connect EKTSDG
2. Start EKTSDG-Remote software or check the windows control panel to get the assigned
COM port. Close EKTSDG-Remote software before opening terminal software!
3. Open a terminal program like Windows Hyper Terminal
4. Select the appropriate COM port. All other settings are not used.
5. Press [Enter]. Now, the following screen (Fig. 4) should appear:
6.1 Terminal Mode: Remote Control
EKTSDG 24GHz Doppler Target #09200100
==============================================
Program Version V1.00 Aug 21 2009
Default Preset : 1 [0=none, 1..3=Preset]
[d] Direction of Motion : 0 [0=Forward, 1=Backward]
[s] Speed : 3 [001..200km/h]
[r] Reach : 100 [001..100%]
[t] Target On/Off : 1 [0=Off, 1=On]
[p] Presets Setup
[x] Back to manual mode
->
Figure 4: EKTSDG Terminal Remote Control Dialog
These settings are directly executed, as long as EKTSDG remains connected to the USB port.
With [p], you will be able to configure the preset memory.