Use and Care Manual

1
Thank you for purchasing a Snap-Loc Cargo Control Systems product!
Snap-Loc Dolly System Manual
Limitations
Cargo on the Dolly should not exceed a maximum weight of 1,500 pounds (680 kg.) and
should be evenly distributed across the entire surface. When loading, place cargo gently on
dolly surface. If cargo is dropped on the Dolly, the impact multiplies the weight of the
cargo significantly and may cause damage that is not covered under warranty. Do not over
tighten straps, this may cause damage to the Dolly, strap, cargo, anchor point and
Snaplocs. Do not expose straps to sharp edges, acids, chemicals or items that may cause
damage to fabric. Always make sure nothing is close to or touching the E-Fitting release
leaver when in use as this may cause it to release. After strapping cargo, always secure
leftover unused strap. If secured cargo has sharp edges or is subject to emitting heat or
chemicals it may cause failure of straps. Push/Panel bars are not to exceed a maximum
torque of 400 pounds . Weight limits on Push/Panel bars will be significantly
reduced if used on an incline. If your Dolly came with individual bolt on Snaplocs strap
anchors, they are rated at 3000 pounds Break Strength (1361 kg.) and 1,000 pounds
working load (454 kg.). Snaplocs can be used almost anywhere, however it is your
responsibility to determine suitability of this product for any particular use. This product is
only as strong as stated when what you anchor them to is as equally strong. Storage of all
Snap-Loc products should be in a dry place not susceptible to elements of weather. Always
read and follow all installation and usage instructions carefully. Keep in mind that some
parts of this product may scratch or cause damage to cargo and vehicle if not properly
protected and secured. If there are any further questions contact your local Snap-Loc
dealer or one of our customer service representatives. Visit our website or call for more
information on Snaplocs and other system Accessories.
Warranty
The Snap-Loc Dolly, Snaplocs (a.k.a. Loc-Downs), Straps and system Accessories are
warranted to be free from defects in material and workmanship for a period of 90 days
(warranty period) from date of purchase, or if you placed a special order with us from date
of receipt of product. Some items may have up to a 1 year warranty depending on store of
purchase (check with Snap-Loc or store of purchase). During the warranty period Snap-
Loc will, at its option, repair or replace without charge any part of our product found to be
defective in material or workmanship (shipping cost may be subject to charge). This
warranty does not extend to any product which has been subject to misuse, abuse,
negligence, accident, alteration, improper installation, over tightening of straps,
superseding recommended weight limits, scratches, discoloring, damaged caused by
usage in temperatures below freezing, contact with items over 150 degrees, wetness,
extreme weather conditions, exposure to chemicals, and unauthorized repair . If product
becomes structurally damaged immediately discontinue use. In no way will Snap-Loc
Cargo Control Systems, LLC (Snap-Loc) be liable for special, direct, indirect or
consequential damages, loss of vehicle, cargo, profits, personal injury, death or the like for
any reason. Please contact our customer service department or the store of purchase for
more details. The literature included with this product has been written for your safety. If
you do not accept the terms and conditions herein do not use this product and return it
within 7 days after purchase. By keeping this product you are agreeing to these terms and
conditions. If returning products, return them to the store of purchase within the warranty
period. No returns will be accepted after the warranty period unless special provisions
have been made with the store of purchase (see store of purchase for further details). If you
purchased your product directly from Snap-Loc please contact the Snap-Loc Customer
Service Department for a Return Merchandise Authorization (RMA) number and return
shipping instructions. Products returned to Snap-Loc without an RMA number will not be
accepted. After receipt of an RMA number, the defective product must be returned to
Snap-Loc within 30 days of the RMA approval of it will result in loss of refund or
replacement.
How to Use
The Snaploc Dolly: Figure 1; Dolly is designed to hold up to 1,500 pounds (680 kg.)
of evenly distributed weight. Safety should be your number one concern and use of weight
belts, gloves and similar safety items should be used. When lifting heavy objects always
get assistance from other people. Load your cargo evenly and with balanced distribution
across the surface. We recommend using the strap attachment feature for moving all loads
as cargo may fall off if not properly strapped down. Be cautious when using on hills and
uneven surfaces as this can be dangerous and cause considerable damage to cargo and/or
injury to persons. Figure 2; To help keep the dolly from rolling, push down the “ON” side
of the casters brake pedal. Figure 3; To release the brake, push the “OFF” side of the
casters brake pedal. The casters were designed to roll across smooth hard surfaces and
should not be used on dirt or rough surfaces. Always use and store in a dry place.
1 2 3
E-Fitting and Snaplocs: Figure 1; When installing the E-Fitting strap end into a
Snaploc or Dolly frame strap anchor (a.k.a. Snaploc) simply pull back on the leaver and
insert shown end into Snaploc. Figure 2; Insert rest of fitting fully into the Snaploc.
Figure 3; Release leaver and click securely in place. Make sure the E-Fitting strap end is
as shown in Figure 3 fully secured in its place before use. Always make sure nothing is
close to or touching the E-Fitting release lever when in use as this may cause strap to
release.
1 2
3