Full Product Manual

Limitations
Cargo Net Working Load Limit is 400 lbs of evenly distributed contained weight with a minimum of 4 connection points. Do not over tighten; this may cause damage to net,
rope, cinch, cargo and anchor points. Though cargo net can be used almost anywhere, it is your responsibility to determine suitability of this product for any particular use.
This product is only as strong as stated when what you anchor them to is as equally strong. Cargo net is subject to damage by elements of weather and may void the warranty.
Cargo Net should be regularly inspected and replaced if worn or damaged. Continuous exposure to ultra-violet light, extreme cold or extreme heat can degrade the strength.
Storage of net should be in a dry place not susceptible to elements of weather. Do not exceed "Working Load Limit". Always keep in mind that “Dynamic G-Forces” will
compromise weight limits such as quickly reducing the speed at which the cargo is traveling and wind resistance. “Working Load Limit” is the maximum load a component
or assembly should be subjected to during routine use. All ratings are based on the product being new and with usage in average environmental conditions. For any particular
use, check with applicable industry, trade association, federal, state and/or local regulations. Always read and follow all installation and usage instructions carefully. Do not
expose to sharp edges, acids, chemicals or items that may cause damage. Products are subject to age, wear and deterioration which can cause a reduction in the products
working load limit. When traveling, we recommend periodically checking cargo and net to insure they are safely secure. If secured cargo has sharp edges or is subject to
omitting heat or chemicals it may cause failure of net. If there are any further questions contact your local Snap-Loc dealer or one of our customer service representatives.
E. Black nylon stow bag
allows for
storage when Cargo Nets are not in
use.
Closed Open
B. Safety Snap Hook or Aluminum
Carabiner attaches from cinch rope to
vehicle tie downs.
A.
Cinch Lock Handle
: Lift up
slightly, turn to right at 90 degrees
to open for tightening or letting
out more cinch rope.
Reverse to lock.
D. Cinch rope
can be pulled out
at numerous points to adjust to
various load shapes and
heights, and then pulled tight.
Tighten r ope lock at r
ear
of net
where rope lock is placed.
C. Safety Snap Hook or
Aluminum Carabiner
should be attached to Cargo
Net cinch rope then to all
vehicles tie- downs, internal
or external.
N
OTE
:
ALL ATTACHING HARDWARE
S
HOULD BE ATTACHED TO THE
CINCH ROPE NOT
THE ROPE BORDER.
FOR LOAD FLOOR AND OR CARGO BED
(INTERIOR OR EXTERNAL USE)
To Feed Cinch Rope Into Net
Lift Black rope lock handle slightly and Turn 90
degr ees to right . Feed cinch rope into the net and
p
ull cinch rope with attachm ents out of net to the
vehicle brackets, then attach. Af ter the net
has been adjusted for height and load
configur ation, start pulling the cinch r ope slack
from the front of the net to the rear. When the net
is tight and secur e over load, run the r ope
lock up to the net and lock in place. Coil balance of
rope and secur e using the Hook & Loop Strap
ovided (a
ttached to the net).
Cargo Net Manual
Warranty
Cargo Net and system Accessories are warranted to be free from defects in material and workmanship for a period of 90 days (warranty period) from date of purchase, or if you
placed a special order with us from date of receipt of product. Some items may have up to a 1 year warranty depending on store of purchase (check with Snap-Loc or store of
purchase). During the warranty period Snap-Loc will, at its option, repair or replace without charge any part of our product found to be defective in material or workmanship
(shipping cost may be subject to charge). This warranty does not extend to any product which has been subject to misuse, abuse, negligence, accident, alteration, improper
installation, over tightening, superseding recommended weight limits, scratches, discoloring, or unauthorized repair. If product becomes structurally damaged immediately
discontinue use. In no way will Snap-Loc Cargo Control Systems, LLC (Snap-Loc) be liable for special, direct, indirect or consequential damages, loss of vehicle, cargo, prots,
personal injury, death or the like for any reason. Please contact our customer service department or the store of purchase for more details. The literature included with this
product has been written for your safety. If you do not accept the terms and conditions herein do not use this product and return it within 7 days after purchase. By keeping
this product you are agreeing to these terms and conditions. If returning products, return them to the store of purchase within the warranty period. No returns will be accepted
after the warranty period unless special provisions have been made with the store of purchase (see store of purchase for further details). If you purchased your product directly
from Snap-Loc please contact the Snap-Loc Customer Service Department for a Return Merchandise Authorization (RMA) number and return shipping instructions. Products
returned to Snap-Loc without an RMA number will not be accepted. After receipt of an RMA number, the defective product must be returned to Snap-Loc within 30 days of the
RMA approval of it will result in loss of refund or replacement.