Installation Guide

ManualsBrandsSnap-N-Seal ManualsKitchen24 in. x 36 in. Storm Window Frame Kit

Made with

Shields your

home from

leaky window

drafts

Saves energy

Cuts fuel bills

INTERIOR

WINDOW INSULATOR

SYSTEM

Snap-N-Seal

Installing the Snap-N-Seal

Window Insulator System

1) Open the trim up fully and peel the clear protective

masking from both sides of the acrylic sheet.

2) Attach the clear sill trim piece to the bottom edge of

the sheet. Make sure to face the tab facing outward for

easier removal.

3) Install the acrylic sheet into the open trim pieces.

4) Snap the trim pieces closed onto the edges of the

sheet.

For windows without sills use the same trim piece that

is used for the other 3 sides for your bottom piece. In

some cases, you may have to purchase another trim

piece (item # 2160) to produce the bottom piece.

5) Peel the protective masking from the adhesive on

the back of the trim pieces. Line your finished Snap-N-

Seal indoor window up carefully and press firmly into

place.

For best results, push down on the window to squeeze

the flexible seal on the bottom of the sill piece to ensure

a good seal to the window sill. Then work up on each

side pressing the trim pieces against the window trim

until the entire indoor window insulator system is tightly

sealed.

The Components:

3. Sharp snips - Sold separately. Recommended for

easy cuts.

Trim strips - They’re vinyl, with self-adhesive backing

that sticks to your window molding or directly to the wall.

(The specially-shaped version shown at the right is for

windows with sills).

1. Clear acrylic sheet - After learning how to measure for

Window Insulator System, purchase the appropriate

size sheet. It’s easily trimmed to the ﬁnished size.

Tools Needed:

1. Measuring tape

2. Pencil and ﬁne tip marker

3. Acrylic scoring knife

4. Safety glasses

5. Fine-toothed hand saw or sharp snips

Straight edge about 6 feet long

Detailed instructions are included in the Snap-N-Seal

Window Insulator Kit to assist you in determining the

correct application for your window type.

Windows With a Sill Windows Without a Sill

•

Easy Do-It-

Yourself

Project

Summary of content (2 pages)

PAGE 1
Installing the Snap-N-Seal Window Insulator System TM The Components: 1) Open the trim up fully and peel the clear protective masking from both sides of the acrylic sheet. 2) Attach the clear sill trim piece to the bottom edge of the sheet. Make sure to face the tab facing outward for easier removal. 3) Install the acrylic sheet into the open trim pieces. 4) Snap the trim pieces closed onto the edges of the sheet.
PAGE 2
Do you have drafty, single pane, yet beautiful existing windows? Don’t install expensive replacements; add the Interior Insulator Window with non-yellowing, crystal clear acrylic that maintains the attractiveness of your home, helps shield the cold from entering and the air conditioning from escaping. Potential Savings: Heat losses through your windows account for the major portion of your heating and cooling bills.