User's Manual
Table Of Contents
- 17 MARS-3102 User Manual_0904
- 17 MARS-3102 User Manual_0731
- Safety Information
- Contents
- Using This Manual
- Introduction
- Getting Started
- Navigation
- Scanner Operations
- OBD Direct Operations
- Component Test Operations
- Scope Multimeter Operations
- Ask-a-Tech Operations
- Information Operations
- Vehicle History Operations
- Data Manager Operations
- Help Operations
- System Settings Operations
- Maintenance
- Software License Agreement, North America
- Index
- 文件2
- 17 MARS-3102 User Manual_0731
- RF Exposure Information (SAR) CCS
11
Chapter 3 Getting Started
Make sure the Display Device has a charged battery or is connected to an AC/DC power supply
(see
Power Sources on page 8). It is highly recommended to back up personal and saved data to
a USB mass storage device on a regular basis to prevent loss in the event of system corruption or
hard disk drive failure.
3.1 Powering Up
Press the Display Device Power button to switch the unit on. The system boots up, then opens the
Home screen (
Figure 3-1).
1. Module Buttons
2. Toolbar
3. Windows Toolbar
Figure 3-1 Sample Home screen
3.1.1 Module Buttons
The Module buttons configure the Display Device for the type of test to be performed.
Table 3-1 on
page 12 gives brief descriptions of the available Module buttons, which operations are available
depends upon the individual configuration of your system. Use the stylus or your finger tip to select
from the Module buttons.