User's Manual

Draft 4/14/15- Do Not Distribute
107
Scope and Multimeter Operations Operations
Unit Setup
The Unit Setup dialog box allows you to switch between Full Scale or Per Division settings for the
trace setup and the display settings. Selecting Full Scale configures the units to the full viewing
area of the screen, while Per Division adjusts the units to a single division (one tenth) of the
screen.
The selected radio knob on the Units dialog box shows which setting is active. Use your finger or
the stylus to switch between settings (Figure 8-26).
Figure 8-26 Sample View Units dialog box
Setup Controls
Basic tool settings are adjusted here.
z To adjust setup controls:
1. Select Setup from the Scope Multimeter toolbar.
The Scope Multimeter Preferences dialog box opens
2. Select Setup from the dialog box.
A submenu of options displays:
– Back—use to return to the Preferences dialog box.
– Units—use to set how measurement values display, US standard or metric.
– Snapshot—use to adjust the percentage of data captured following a trigger event.
– Ignition—use to configure the ignition scope for the test vehicle.
Selecting from the submenu opens a dialog box for that item. Dialog box options for each item
are discussed in the following sections.
3. Make dialog box selections as needed.
4. Select Exit to close the dialog box and return to the scope.