Product Manual

• If you get spray nozzle too close, especially using high pressure mode, you may

damage surface being cleaned.

• DO NOT get closer than 6 inches when cleaning tires.

SHUTTING DOWN THE PRESSURE WASHER

The Pressure Washer motor runs only when the trigger is engaged. To shut off the

Pressure Washer:

1. Release spray gun trigger.

2. Move unit's ON/OFF switch to OFF position.

IMPORTANT: Releasing the trigger will shut off the motor but does not shut off elec-

trical power to the unit.

3. Turn off water supply.

4. ALWAYS point spray gun in a safe direction and squeeze spray gun trigger to

relieve built up pressure in the unit.

Spray gun traps high water pressure, even when motor is

stopped and water is disconnected.

5. Engage trigger lock on spray gun when not in use. Place the gun in its holder on

the side of the unit.

6. Disconnect GFCI plug from outlet and wrap power cord around the Power Cord

Hook at the back of the pressure washer. Store the GFCI plug inside its housing

in the center of cord intake.

7. Disconnect pressure washer from water supply and store the unit (see MAINTE-

NENCE section).

USAGE OF CLEANING DETERGENTS

TO APPLY DETERGENT:

1. Select a detergent/cleanser appropriate for the intended application.

2. Prepare detergent solution as recommended by the manufacturer.

3. Remove the detergent tank lid located at the top of the Pressure Washer.

4. Fill tank with prepared detergent solution. A small funnel may help with this task.

Replace the detergent tank lid.

5. Set (turn) the Pressure Adjust Collar to low pressure position.

Detergent will NOT flow until the Pressure Adjust Collar is

set (turned) to low pressure position.

6. Pull spray gun trigger and apply detergent to a dry surface, starting at lower portion

of area to be washed and work upward, using long, even, overlapping strokes.