Manualshelf

A350 - Troubleshooting-Guide

ManualsBrandsSnapmaker ManualsRobotics2.0 Modular 3-in-1 3D Printer
31323334353637383940
30
|
Hardware
4. Wait for thenozzle toreach 200
℃
, tapLoad orUnload, and see if the gear in themodulerotates.
- If it does, then change the toolhead cable.
- If it doesn't, then the Controller is broken.It might be that the customer has connected the toolhead cable in
the wrong direction, and the toolhead and the Controller is damaged as a result. You will need to first replace
the Controller. Then,check if the 3D Printing Module and Laser Module works with the new Controller.
If not, these modules may also be broken and need to be replaced.
5. Replace the toolhead cablewith the Y or Z conversion cable to see ifthe Laser Module emits light.If it does,
thenthe previous toolhead cable is brokenand needs to be replaced.
Z Conversion CableY Conversion CableToolhead Cable