Quick Start Guide

steps.
16. Select the last straight module ("X" identification at the junction) which will be used as the X axis.
All straight line modules must be installed in the specified position and cannot be
mixed for machine failure or damage.
17. Put the pin on the X-axis adapplate into the pin hole of the X-axis straight module (the X-axis).
Make sure that the pin is fully inserted into the pin hole.
18. Install and lock the screws to secure X axis to X axis adapter plate.
19. Install and lock the screws and secure the three presses to the Z and X axes.
20. Card the X axis and the execution head connector into the press cord buckle.
21. Install and lock the screws to secure the execution head quick change slide seat to the X-axis slide car.
22. Move the Y-axle slide to the most front end that it can reach.
23. Install and lock the screws to secure the support platform to the Y-shaft pulley.
When installing the screws, follow the following steps:
1. Pre-lock the four screws at the outermost corner;
2. Pre-lock the remaining screws;
3. Pull the support platform forward with one hand and lock all screws with a
wrench.(Here is a real picture.)
* Pre-lock: screw the screw into the screw hole but not completely.
24. Place your hands on the bottom of both ends of the X axis and lift the X axis to above the Z axis bracket.
This step is to install the execution head and working platform in subsequent
steps.