Quick Start Guide

3 Cover assembly and use
3.1 Outer Cover Assembly
The
①
assembled the bottom frame
Encourage language: a good beginning, is half the success! Are you getting a —— ready?
1. Secure the bottom fixtures (top) to two long beams.
￮ Screw: M4 20 screws, 2 screws
2. Secure profile connections to both ends of two long beams.
￮ Screw: M5 12 screws, 4 screws
Ensure that the limit abutment of the profile connector is located in the grooves
on both sides of the beam.
Ensure that the four profile connections are inside side up.
3. Secure short beam (rear) to profile connector.
￮ M5 12 screws, 2 screws
There are two screw holes in the middle of the short beam (rear). make sure the
screw holes face up when mounting.
Ensure that the limit bumps of the profile connections are located in the grooves
on both sides of the beam.
4. Attach the short beam (front) to the profile connector to assemble the bottom frame.
￮ Screw: M5 12 screws, 2 screws
Ensure that the limit bumps of the profile connections are located in the grooves
on both sides of the beam.
② assembly support frame
Encouraging words: Start installing columns on the bottom frame, you're about to complete 30% of the
assembly!
1. Secure the post-1 (with door closure) to the bottom frame.
￮ Screw: M5 30 screws, 2 screws
Ensure that the limit bumps of the profile connections are located in the grooves
on both sides of the column.
You can also put the bottom frame up first, and then install the column.